Abstract:(Zr62Cu15.4Ni12.6) (x = 6–12) in situ glassy composites containing uniformly distributed Ta-rich particles were prepared by arc-melting and copper mould casting. The results show that addition of 6–10 at.% Ta to Zr62Cu15.4Ni12.6Al10 results in dissolution of 2.4 to 4.6 at.% Ta in the glassy matrix, which promotes glass-forming ability, and the remaining Ta precipitates out as body-centered cubic (BCC) Ta-rich particles dispersed on the glassy matrix. The critical diameters for the composites with 6, 8, and 10 at.% Ta are 7, 7, and 6 mm, respectively. At 12 at.% Ta addition, the glass-forming ability is dramatically reduced because of the precipitation of secondary dendritic Ta-rich particles and other nanocrystallites from melts during copper mould casting. Also, owing to the solid-liquid reaction during induction heating, some Ta-rich particles formed in the master alloys will redissolve into the glassy matrix, resulting in a smaller volume fraction of Ta-rich particles in the as-cast glassy rods than that of the corresponding ingots. The glassy matrix composites exhibit enhanced plastic strain of about 7.5 to 22.5% at room temperature. The optimum Ta content in the glassy alloys is determined to be 10 at.%, which corresponds to the highest ultimate stress of 2220 MPa and the largest plastic strain of 22.5%. The plastic strain increases with increasing volume fraction of in situ BCC Ta-rich particles. This is apparently ascribed to the impedance of Ta-rich particles to shear bands. Ta-rich particles seed the initiation of multiple shear bands and block the shear band propagation, leading to intensive multiplication and bifurcation of shear bands.

Metallic glass matrix composite with precipitated ductile reinforcement

Structure and properties of Zr–Ta–Cu–Ni–Al bulk metallic glasses and metallic glass matrix composites

Zr-Cu-Ni-Al-Ta Glassy Matrix Composites with Enhanced Plasticity

Development of Zr-based metallic glass matrix composites with hybrid reinforcing structures

Cu–Hf–Ti–Ag–Ta bulk metallic glass composites and their properties

Novel metal matrix composites reinforced with Zr-based metallic glass lattices

Improving the glass-forming ability and plasticity of a TiCu-based bulk metallic glass composite by minor Ta doping

A High-Strength Co–Fe–Ta–B Metallic-Glass Phase Enabled Tensile Plasticity in Co–Fe–Ta–B–O Oxide Glass Matrix Nanocomposites

Microstructure and mechanical behavior of metallic glass fiber-reinforced Al alloy matrix composites

Concurrently achieving strength-ductility combination and robust anti-wear performance in an in-situ high-entropy bulk metallic glass composite

Heterogeneous metallic glass composites with a unique combination of strength, plasticity and conductivity

Development of high-entropy metallic glass matrix composites with enhanced compressive mechanical properties at elevated temperatures

Development of tough, low-density titanium-based bulk metallic glass matrix composites with tensile ductility

Microstructure and Deformation Mechanism of Titanium-Based Metallic Glass Matrix Composites

Versatile Medium Entropy Ti-Based Bulk Metallic Glass Composites

Development of High Strength Ni–Cu–Zr–Ti–Si–Sn In-Situ Bulk Metallic Glass Composites Reinforced by Hard B2 Phase

Mechanical and corrosion properties of Ti-Ni-Cu-Zr metallic glass matrix composites

Structural and mechanical characterizations of ductile Fe particles-reinforced Mg-based bulk metallic glass composites

Modulating the microstructure and mechanical properties of β-Ti-reinforced bulk metallic glass composites by carbon addition

Centimeter-sized Ti-based Bulk Metallic Glass with High Specific Strength

High-strength and malleable dual-phase nanostructured Ta-based metallic glass via atomic manufacturing