Abstract:This study demonstrates the successful fabrication of near-full density monophasic tetragonal 1.5-mol% yttria-stabilized zirconia (1.5YSZ) ceramics using current-ramp flash (CRF) sintering technique. The process involved regulating Joule heating in the samples by fine-tuning the input power through an alternating current field (nominal current density: 50 mA·mm −2 ) within a 3-minute timeframe at a furnace temperature of 1100°C. This approach effectively enhanced grain size uniformity, which is crucial for preventing sample cracking associated with spontaneous tetragonal-to-monoclinic (T→M) phase transformation, thereby promoting densification with average relative densities exceeding 99%. The highest average fracture toughness of the 1.5YSZ samples was measured at 9.2 MPa·m 0.5 using the standardized single-edge pre-cracked beam method. This toughness is approximately double that of commonly used 3YSZ samples produced by CRF sintering, all of which exhibited comparable average grain sizes and relative densities. Additionally, the 1.5YSZ samples demonstrated nearly identical resistance to low-temperature degradation (LTD) compared to the 3YSZ samples after accelerated hydrothermal aging at 140°C for 15 hours, roughly equivalent to 60 years at 37°C. The reduced yttria concentration in 1.5YSZ facilitates T→M phase transformation at lower stress thresholds, enhancing toughness through increased crack shielding from a larger volume fraction of transformed grains. Furthermore, the uniform yttria distribution in 1.5YSZ, revealed by scanning transmission electron microscopy, compensates for the reduced tetragonal phase stability and contributes to improved LTD resistance. Notably, these exceptional properties were achieved at a furnace temperature 300°C lower and with a sintering duration several hours shorter than those of conventionally-sintered counterparts.

Zr 1 _ YW 2 O 8-ƒÂ ( x = 0 . 000 . 02 ) Ceramic Using Reactive Sintering

Effect of Yb Substitution on Microstructure, Physical and Mechanical Properties of Negative Thermal Expansion Zr1−xYbxWMoO8−x/2 (x = 0–0.05) Ceramic

Zr 1− X Yb X WMoO 8− X /2 ( X = 0, 0.04) Ceramics Fabricated by in Situ Synthesis from Trigonal Polymorph: Preparation, Sintering Process, and Negative Thermal Expansion Properties

Coprecipitation synthesis and sintering property of (Yb<SUB>x</SUB>Sm<SUB>1-x</SUB>)<SUB>2</SUB>Zr<SUB>2</SUB>O<SUB>7</SUB> ceramic powders

Coprecipitation Synthesis And Sintering Property Of (Ybxsm1-X)(2)Zr2o7 Ceramic Powders

(Zro 2 ) 0.85 ( RE O 1.5 ) 0.15 ( RE =sc, Y) Solid Solutions Prepared Via Three Pechini-type Gel Routes: 2—sintering and Electrical Properties

Cold Sintering Process for 8 Mol%y2o3-Stabilized ZrO2 Ceramics

Conventional sintering of nano-crystalline Yttria-Stabilized Zirconia enables high-strength, highly translucent and opalescent dental ceramics

Manufacture process of 8Y<sub>2</sub>O<sub>3</sub> stabilized ZrO<sub>2</sub> from nano powders

Preparations and Characterizations of New Mesoporous ZrO2 and Y2O3-stabilized ZrO2 Spherical Powders

Preparation Processes Of The Zro2/Zrw2o8 Ceramic Composites

Phase composition, microstructure and thermophysical properties of the Srx(Zr0.9Y0.05Yb0.05)O1.95+x ceramics

Electrical Properties and Applications of （zro2）0.92 （Y2O3）0.08 Electrolyte Thin Wall Tubes Prepared by Improved Slip Casting Method

Realizing near-full density monophasic tetragonal 1.5-mol% yttria-stabilized zirconia ceramics via current-ramp flash sintering

Compacting and Sintering Behavior of Nano ZrO 2 Powders

Controlled sintering and phase transformation of yttria-doped tetragonal zirconia polycrystal material

Preparation and Improved Grain Conductivity of (sm[sub 1−x]y[sub X])[sub 2]zr[sub 2]o[sub 7] Ceramics

Doping Effects of Yb3+ on the Crystal Structures, Nanoparticle Properties and Electrical Behaviors of ZrO2 Derived from a Facile Urea-Based Hydrothermal Route

Microstructure and Mechanical Properties of ZrO2-2 Mol% Y2O3 Ceramics

Preparation Of Y-Tzp Nanoceramics By Gelcasting-Pressing And Pressureless Sintering

Thermal Conductivity of Ytterbia-Stabilized Zirconia