Heat transfer and entropy generation analysis of HFE 7000 based nanorefrigerants 1 2

H. Helvacı,Z. Khan

2016-01-01

Abstract:24 In this study, two dimensional numerical simulations of forced convection flow of HFE 7000 25 based nanofluids in a horizontal circular tube subjected to a constant and uniform heat flux in 26 laminar flow was performed by using single phase homogeneous model. Four different 27 nanofluids considered in the present study are Al2O3, CuO, SiO2 and MgO nanoparticles 28 dispersed in pure HFE 7000. The simulations were performed with particle volumetric 29 concentrations of 0, 1, 4 and 6% and Reynolds number of 400, 800, 1200 and 1600. Most of 30 the previous studies on the forced convective flow of nanofluids have been investigated 31 through hydrodynamic and heat transfer analysis. Therefore, there is limited number of 32 numerical studies which include both heat transfer and entropy generation investigations of 33 the convective flow of nanofluids. The objective of the present work is to study the influence 34 of each dispersed particles, their volume concentrations and Reynolds number on the 35 hydrodynamic and thermal characteristics as well as the entropy generation of the flow. In 36 addition, experimental data for Al2O3-water nanofluid was compared with the simulation 37 model and high level agreement was found between the simulation and experimental results. 38 The numerical results reveal that the average heat transfer coefficient augments with an 39 increase in Reynolds number and the volume concentration for all the above considered 40 nanofluids. It is found that the highest increase in the average heat transfer coefficient is 41 obtained at the highest volume concentration ratio (6%) for each nanofluids. The increase in 42 the average heat transfer coefficient is found to be 17.5% for MgO-HFE 7000 nanofluid, 43 followed by Al2O3-HFE 7000 (16.9%), CuO-HFE 7000 (15.1%) and SiO2-HFE 7000 44 (14.6%). However, the results show that the enhancement in heat transfer coefficient is 45 accompanied by the increase in pressure drop, which is about (9.3 28.2%). Furthermore, the 46 results demonstrate that total entropy generation reduces with the rising Reynolds number 47 and particle volume concentration for each nanofluid. Therefore, the use of HFE 7000 based 48 MgO, Al2O3, CuO and SiO2 nanofluids in the laminar flow regime is beneficial and enhances 49 the thermal performance. 50