Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Numerical Research on Convective Heat Transfer and Resistance Characteristics of Turbulent Duct Flow Containing Nanorod-Based Nanofluids

Convective Heat Transfer and Resistance Characteristics of Nanofluids with Cylindrical Particles

Numerical study of the effects of nanorod aspect ratio on Poiseuille flow and convective heat transfer in a circular minichannel

Natural convection heat transfer in concentric annuli with nanofluids

Flow and Heat Transfer Characteristics of Nanofluids Containing Rod-Like Particles in a Turbulent Pipe Flow

Investigation on Convective Heat Transfer and Flow Features of Nanofluids

Pressure Drop and Heat Transfer of Nanofluid in Turbulent Pipe Flow Considering Particle Coagulation and Breakage

Flow and Heat Transfer Property of Oldroyd-B-Fluid-Based Nanofluids Containing Cylindrical Particles in a Pipe

Friction Factor And Heat Transfer Of Nanofluids Containing Cylindrical Nanoparticles In Laminar Pipe Flow

Experimental Study on the Convective Heat Transfer of Cuo-Water Nanofluid in A Turbulent Flow

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Enhancing and Attenuating Heat Transfer Characteristics for Circulating Flows of Nanofluids Within Rectangular Enclosures

Heat Transfer and Pressure Drop of Nanofluid with Rod-like Particles in Turbulent Flows Through a Curved Pipe.

Numerical Modeling of Turbulent Heat Transfer of a Nanofluid at Supercritical Pressure

A Numerical Investigation of Transient Natural Convection Heat Transfer of Aqueous Nanofluids in A Horizontal Concentric Annulus

Numerical Study of Natural Convection Characteristics of Nanofluids in an Enclosure Using Multiphase Model

Investigation on Flow and Heat Transfer of Nanofluids by the Thermal Lattice Boltzmann Model

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

Numerical Heat Transfer Enhancement Using Different Nanofluids Flow Through Venturi and Wavy Tubes

Numerical Investigation of Nanofluid Convection Performance in the Fully Developed Flow Regime of the Pipe with Constant Wall Temperature

On the mechanism of convective heat transfer enhancement in a turbulent flow of nanofluid investigated by DNS and analyses of POD and FSP