Abstract:A piezoelectric cantilever (PEC) is a transverse transducer consisting of a piezoelectric layer, e.g., lead zirconate titanate (PZT), bonded to a nonpiezoelectric layer, e.g., stainless steel, which has a uniform cross section throughout the length. A PEC with a thin nonpiezoelectric extension, on the other hand, has two distinctive sections each with its own thickness and transverse mass-density and elastic-modulus profiles. A piezoelectric cantilever with a nonpiezoelectric extension has been increasingly used as an in situ biosensor that has the advantage of dipping only the nonpiezoelectric extension part in an aqueous solution without electrically insulating the piezoelectric section. In this study, we examined both experimentally and theoretically the effect of the thin nonpiezoelectric extension, in particular, its length ratio to the piezoelectric part on the vibration wave form and mass detection sensitivity of a PEC. We showed that the nonpiezoelectric extension caused substantial distortion to the vibration wave form. Due to the wave form distortion, the mass detection sensitivity of a PEC with a nonpiezoelectric extension can be higher than that of a PEC of the same length without a nonpiezoelectric extension. Using PECs consisting of a 0.25 mm thick PZT layer and a 0.07 mm thick stainless steel of various lengths, l(1), and a 0.07 mm thick nonpiezoelectric stainless steel extension of various lengths, l(2), we showed that for any l(1), the maximum mass detection sensitivities of first, second, and third modes occurred at l(2)/l(1)=0.6, 0.28, and 0.16 and the maximum values were, respectively, 1.42, 3.9, and 6.7 times the mass detection sensitivity of a PEC of the same l(1) without a nonpiezoelectric extension. (c) 2006 American Institute of Physics.

A new impedance based sensitivity model of piezoelectric resonant cantilever sensor

Piezoelectric Circuitry Tailoring for Resonant Mass Sensors Providing Ultra-High Impedance Sensitivity

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Identification of Geometric Parameters Influencing the Impedance Sensitivity of Piezoelectric Mass Sensors

A New Sensitivity-Improving Method for Piezoelectric Resonance Mass Sensors Through Cantilever Cross-Section Modification

Design and Analysis of Micro-Mass Sensor Based on I-shaped Cross-Section Cantilever

Method to Further Improve Sensitivity for High-Order Vibration Mode Mass Sensors with Stepped Cantilevers

Modeling And Analysis Of Multiple Attached Masses Tuning A Piezoelectric Cantilever Beam Resonant Frequency

Piezoresistive Slot-Cantilever Type Accelerometer Inspired from Spider'S Slit Sensilla

Mass detection sensitivity of piezoelectric cantilevers with a nonpiezoelectric extension

A new sensitivity improving approach for mass sensors through integrated optimization of both cantilever surface profile and cross-section

Studies of the electromechanical coupling characteristics based on cantilever-mass.

Modified Coefficient of Equivalent Mass to Explain Decreased Relative Sensitivity of Piezoelectric Cantilever Humidity Sensor in High Mode

The study on the analytic model and design software for IP of piezoresistive cantilever beams

Tens Femtogram Resoluble Piezoresistive Cantilever Sensors with Optimized High-Mode Resonance Excitation

Design and characterization of high-sensitivity cantilevers

Design and Analysis of Micro-Mass Sensor Based on Trapezoidal Variable Cross-Section Cantilever

A Mathematical Model of a Piezoelectric Micro- Machined Hydrophone With Simulation and Experimental Validation

Performances and Improvement of Coupled Dual-Microcantilevers in Sensitivity

Sensitivity Enhancement Of A Resonant Mass Sensor Based On Internal Resonance

Theoretical Analysis of Response Mechanisms of Piezoelectric Biosensors Based on Acoustic Impedance Model