Abstract:In this work, the structural and mechanical properties of ternary Mo-Al-N alloys are investigated by combining thin film growth experiments and density functional theory (DFT) calculations. Mo1−xAlxNy thin films (∼300 nm thick), with various Al fractions ranging from x = 0 to 0.5 and nitrogen-to-metal (Al + Mo) ratio ranging from y = 0.78 to 1.38, were deposited by direct-current reactive magnetron cosputtering technique from elemental Mo and Al targets under Ar + N2 plasma discharges. The Al content was varied by changing the respective Mo and Al target powers, at a fixed N2 (20 SCCM) and Ar (25 SCCM) flow rate, and using two different substrate temperatures Ts = 350 and 500 °C. The elemental composition, mass density, crystal structure, residual stress state, and intrinsic (growth) stress were examined by wavelength dispersive x-ray spectroscopy, x-ray reflectivity, x-ray diffraction, including pole figure and <math> si n 2 ψ</math> measurements, and real-time in situ wafer curvature. Nanoindentation tests were carried out to determine film hardness H and elastic modulus EIT, while the shear elastic constant C44 was measured selectively by surface Brillouin light spectroscopy. All deposited Mo1−xAlxNy films have a cubic rock-salt crystal structure and exhibit a fiber-texture with a [001] preferred orientation. The incorporation of Al is accompanied by a rise in nitrogen content from 44 to 58 at. %, resulting in a significant increase (2%) in the lattice parameter when x increases from 0 to 0.27. This trend is opposite to what DFT calculations predict for cubic defect-free stoichiometric Mo1−xAlxN compounds and is attributed to variation in point defect concentration (nitrogen and metal vacancies) when Al substitutes for Mo. Increasing Ts from 350 to 500 °C has a minimal effect on the structural properties and phase composition of the ternary alloys but concurs to an appreciable reduction of the compressive stress from −5 to −4 GPa. A continuous increase and decrease in transverse sound velocity and mass density, respectively, lead to a moderate stiffening of the shear elastic constant from 130 to 144 GPa with increasing Al fraction up to x = 0.50, and a complex and nonmonotonous variation of H and EIT is observed. The maximum hardness of ∼33 GPa is found for the Mo0.81Al0.19N1.13 film, with nitrogen content close to the stoichiometric composition. The experimental findings are explained based on structural and elastic constant values computed from DFT for defect-free and metal- or nitrogen-deficient rock-salt MoAlN compounds.

N thin films by density functional calculations

Ferromagnetism In Al1-Xcrxn Thin Films By Density Functional Calculations

Synthesis, Characterization and Modeling of High Quality Ferromagnetic Cr-doped AlN Thin Films

Ab Initio Study of Ferromagnetism in Ga 1 − X Cr X N Thin Films

Synthesis and Characterization of High Quality Ferromagnetic Cr-doped GaN and AlN Thin Films with Curie Temperatures above 900K

First-principles study of elastic properties of Cr-Al-N

Characterization of Al(Cr)N and Ga(Cr)N dilute magnetic semiconductors

Magnetic and electronic properties of transition metal doped aluminium nitride: Haldane’s approach combined with ab initio results

Clustering of Cr in GaN Nanotubes and the Onset of Ferrimagnetic Order

Influence of Strain and Grain Boundary Variations on Magnetism of Cr-doped AlN Films

Influence of Cr-doping on Microstructure and Piezoelectric Response of AlN Films

Structure and Electrical Conductivity of Thin AlN Films on Si

Nitrogen-Induced Magnetic Transition In Small Chromium Clusters

Effect of Carbon Doping on Microstructure, Electronic and Magnetic Properties of Cr:AlN Films

Structural twinning-induced insulating phase in CrN (111) films

Nitrogen flow rate dependent atomic coordination, phonon vibration and surface analysis of DC Magnetron sputtered Nitrogen rich-AlN thin films

Cr-induced structural phase transformation in sputter deposited poly-AlN thin film from wurtzite to rocksalt structure and their effect on the optical properties

Magnetic Coupling Between Cr Atoms Doped at Bulk and Surface Sites of ZnO

Effects of W alloying on the electronic structure, phase stability and thermoelectric power factor in epitaxial CrN thin films

Structure, stress, and mechanical properties of Mo-Al-N thin films deposited by dc reactive magnetron cosputtering: Role of point defects

Observation of Ferromagnetism above 900 K in Cr-GaN and Cr-AlN