Abstract:Micro-channel cooler is a very promising approach to meet the requirements of microelectronics package cooling. A lot of investigations about micro-channels have been undertaken in the past years. A silicon micro-channel can remove 790W/cm2 heat with a temperature rise of 71 degrees between the substrate and the coolant. The width and height of the silicon channel are 50um and 302um separately [1]. However, as the trends in the electronics industry moves towards higher packaging density, the high-pressure drop problem limits the performance of traditional silicon heat sink. Replacing the silicon fins with nanotube fins to enhance the thermal exchange rate between cooling liquid and substrate is one way to overcome this problem. Growing aligned nanotubes on the whole substrate is another one [2]. Carbon nanotubes (CNTs) are a new form of carbon which was discovered in 1991 by Iijima [3]. CNTs can be grown directly on the surface of silicon accurately according to predefined small-scale catalyst patterns normally transferred by standard photolithography processes. It was reported that nanotubes have an extremely high thermal conductivity over 3000W/(km) [4], so in the present work, the thermo physical properties of CNTs are obtained via molecular dynamics (MD) method. Fig. 1 shows one single-wall CNT simulation by LAMMPS. Several CNTs-fin heat sinks (1cm*1cm) with different fin width varied from 2um to 200um are tested (Fig. 2). Then the aligned CNTs heat sink is also simulated to compare with the long CNTs-fin model. The heat transfer coefficients and pressure drop of these structures are computed. Results indicate replacing the silicon-fin with CNTs-fin is a promising method and the long CNT-fin model shows better performance than the aligned CNTs for generating little pressure drop. Among the models, the best one is chosen for experiments in next work.

The Heat Transfer Performance of the Carbon Nano-Tubes Micro-Channel Cooler in 3-D Stacked Package

Investigation of Reflow Soldering under Nitrogen Atmosphere

Fabrication of Three-dimensional Thermally Conductive Carbon Fibers/Carbon Nanotubes Network Reinforce Epoxy Composites

Effects of Nitrogen on Wettability and Reliability of Lead-Free Solder in Reflow Soldering

Improving Adhesion Strength and Thermal Conductivity of Nanowire Surface Fastener

Carbon Welding by Ultrafast Joule Heating.

Impact of Nitrogen on Lead-free Reflow Temperature

10.1063/1.5084134.2

Effects of Ni-coated Carbon Nanotubes addition on the electromigration of Sn-Ag-Cu solder joints

Design and evaluation of nitrogen-rich welding wires for high nitrogen stainless steel

Ultracompliant Heterogeneous Copper-Tin Nanowire Arrays Making a Supersolder

Microstructural Welding Engineering of Carbon Nanotube/Polydimethylsiloxane Nanocomposites with Improved Interfacial Thermal Transport

Microstructures and mechanical properties of powder-filled laser welding joints composed of high-nitrogen steel

Microstructural and Micromechanical Characteristics of Tin-Based Solders Under Self-Propagating Exothermic Reaction Heating

Design and Test of Carbon Nanotube Biwick Structure for High-Heat-Flux Phase Change Heat Transfer

Cooling Environment Effect on the Microstructure and Mechanical Properties of Friction Stir-Welded Joints

Package heat dissipation with integrated carbon nanotube micro heat sink

Mechanical Response of Cu/Sn58Bi-xNi/Cu Micro Solder Joint with High Temperatures

A study of the heat transfer characteristics of the micro-channel heat sink

In-situ investigation on melting characteristics of 1D SnCu alloy nanosolder

EFFECTS OF HEAT INPUT ON THE MICROSTRUC-TURE AND IMPACT TOUGHNESS OF WELD METAL PROCESSED BY A NEW FLUXNOVEL FLUX CORED WIRE WELD