Abstract:A general two-dimensional (2D) theoretical approach capable of providing an explicit closed-form solution is developed for the calculation of elastic stresses in single-lap adhesive bonded joints, assuming linear distribution of a longitudinal normal stress in the joint thickness direction. By treating the adhesive layer in the same way as the adherends, the two-dimensional stress and strain distributions at any point, and the tensile force, shearing and bending moment at any cross section can be predicted accurately, in both the adhesive and adherends. This makes it possible for the subsequent failure analysis of the bonded joints to predict all the main modes such as adherend failure, cohesive failure and adhesive failure. The analysis is based on a two-dimensional elasticity theory that both includes the complete stress-strain and the complete strain-displacement relationships for the adhesive and adherends. Then, through the use of the displacement continuity conditions at the interfaces between the adhesive and adherends, four coupled, fifth-order ordinary differential equations with constant coefficients for the determination of the stresses are developed. The proposed method is capable of satisfying all the boundary stress conditions of the joint, including the stress-free surface condition at the ends of the bondline. The calibration of the new theoretical approach was verified by comparing it with the previously theoretical solutions, and the 2D geometrically nonlinear finite element models with the rotation and non-rotation boundary conditions. It is indicated that the present solution can provide a good prediction for the stress and strain distributions in the adhesive and adherends. A different approach is also established for determining bending moment factor of the short joints wherein the consideration of overall joint moment equilibrium is emphasized. It was shown that when the proposed bending moment factor is adopted instead of the original one, the classical solution by Goland and Reissner (1944) [4] might still remain applicable to the adherends and adhesive even with the parameter E3t1/(E1t3) 0.1.

Inversion Analysis For Interfacial Stress Of Composite Single-Lap Joint Based On Full-Field Deformation And Fem

Micro Failure Analysis of Fiber Metal Laminates

Analytical Solution for Externally Bonded Joints Considering Snap-Back

Modified Fourier-Galerkin Solution For Aerospace Skin-Stiffener Panels Subjected To Interface Force And Mixed Boundary Conditions

A novel approach based on stress-impedance effect to assess the interfacial properties in fiber-reinforced composites

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

ENHANCED FINITE ELEMENT ANALYSIS OF COMPOSITE BEAMS WITH INTERLAYER SLIPS

Enforcing of an theoretical solution of three adhesive joints into simplified finite element formulations for stiffness prediction

Computational modelling of postbuckling behavior of composite T-stiffened panels with different bonding methods

Interfacial shear stress analysis in single-lap adhesive joints with similar and dissimilar adherends under dynamic loading

Numerical Analysis of Shear Stress on Adhesive Joint Between FRP and Steel Structure in Civil Engineering

Elastic Stress Analysis of Single-Lap Adhesive-Bonded Joints

Determination of Interface Fracture Toughness of Adhesive Joint Subjected to Mixed-Mode Loading Using Finite Element Method

A Two-Dimensional Approach of Single-Lap Adhesive Bonded Joints

Interfacial stress analysis of a thin plate bonded to a rigid substrate and subjected to inclined loading

3-D Elastic Analysis of Stress Transference Mechanism at the Interfaces in Fiber Reinforced Concrete

STRESS ANALYSIS OF CRACKED PLATE WITH ADHESIVELY BONDING

Effect of Frp-To-Steel Bonded Joint Configuration on Interfacial Stresses: Finite Element Investigation

Finite Element Analysis of Low-Speed Oblique Impact Behavior of Adhesively Bonded Composite Single-Lap Joints

Simplified Finite Element Formulation of Unsymmetrical Adhesive Joints Based on Analytical Solutions

A TWO-DIMENSIONAL SOLUTION FOR UNSYMMETRIC SINGLE-LAP ADHESIVE BONDED JOINTS