Abstract:The capacities of industrial coal-fired boilers are normally less than 20-30MWe. And these coal-fired boilers of low capacity are facing the severe situation of low efficiency and heavy environmental pollution. Hence, an innovative horizontal circulating fluidized bed (HCFB) boiler was developed to enhance heat efficiency and reduce pollutant emission of industrial boilers in China. The chamber in the HCFB boiler consists of primary combustion chamber, secondary combustion chamber and burnout chamber, which were combined horizontally side by side. To verify the conception of horizontal fluidized circulation and to obtain the characteristic data, a 0.35 MWth coal-combustion HCFB boiler was designed and installed to perform some experiments of combustion and mass circulation. In the boiler there were two mass circulating paths, one is inner circulating through the inertia separator and another was external circulating through the cyclone separator. The connection bottom of the secondary chamber and the burnout chamber was designed as an inertia separator, in which separated and collected solid materials were returned to the primary combustion. In fact the secondary separator was a small cyclone separator connecting to the exit of the burnout chamber. Heat efficiency and separating efficiency of the experimental boiler were measured and analyzed. Furthermore, mass and temperature distribution along the chambers height were also investigated. The results showed that the heat efficiency of the bare boiler was 82%. The mass balance based on ash content was measured and analyzed. Separating efficiency of the inertia separator and cyclone separator was 60% and 99.9%, respectively. It showed that the two stage material separation and circulation enhanced coal combustion in the HCFB boiler and help to minimize the height of the furnace.

Retrofitting Technique of 65t/h Pulverized Coal-fired Boiler and Its Operation Performances

Retrofitting of a Planar Separator Circulating Fluidized Bed Boiler

ANALYSIS OF RETROFITTING SCHEME FOR A COMBINED CYCLE WITH BOILER USING EXHAUST GAS FOR SUPPORTING COMBUSTION

Optimization adjustment of pulverizing system for a 600 MW unit boiler burning mixed inferior coal

Retrofitting of 75 t/h tower type circulating fiuidized bed combustion boiler

Impact of Coal Types and Pulverizing Methods on the Thermal Performance of Blending Coal-Fired Boilers and Their Operational Optimization

Retrofit of Boiler in Shenhuolv Power Plant for Conversion the Kind of Coal

Operational Performance and Optimization of A 465t/h Cfb Boiler in China

DESIGN AND OPERATION OF RETROFITTING CHAIN-GRATE BOILER INTO A CFB BOILER

Retrofit of Burners of 410 T/h Boiler for Conversion from Burning Bituminous to Burning Lean Coal

Retrofitting Strategy and Operating Technology of Pure Burning Zhundong Coal in a 135 MW Circulating Fluidized Bed Boiler

Experimental Investigation on a 0.35 MWth Coal-Fired Horizontal Circulating Fluidized Bed Boiler

Design and performance of a circulating fluidized bed boiler firing stone coal

Experiment-study of firing system retrofitting of 1025 t/h boiler in Xibaipo Power Plant

Improving the Combustion Performance of a 660mwe Down-Fired Utility Boiler by Adopting High Efficiency Combustion Technologies

Combustion System Renovation of 125MW Unit for Enhancing Coal Suitability and the Influence on NOx Emission

Numerical Study and Hydrodynamic Calculation of the Feasibility of Retrofitting Tangentially Fired Boilers into Slag-Tap Boilers

TECHNOLOGY OF RETROFITTING DESIGNED 220 T/h OIL-FIRED BOILER INTO COAL-WATER-SLURRY FIRED ONE AND APPLICATION THEREOF

Novel CFB Boiler Technology with Reconstruction of its Fluidization State

97/02089 Design and performance of a circulating fluidized bed boiler firing stone coal

Design and Operation of a 20 t/h Circulating Fluidized Bed Boiler System Burning Coal Slime