Abstract:Currently there still exist a large base of subcritical coal-fired boilers remaining in operation worldwide. Improving their thermal efficiency is critical for these units to reduce the cost of electricity and meet the increasingly stringent efficiency regulations. This paper presented an economic high temperature upgrading retrofit solution for these subcritical units in which the final superheat and reheat steam temperatures are elevated from 540 °C to 600 °C level while the steam pressures remain at subcritical such that the retrofit can be made with minimum modifications to the boiler to reduce retrofit cost and technical risk. A systematic analysis was first conducted to deduce the best boiler heating surface modification option to achieve such significant increase of boiler steam temperatures. The analysis shows that replacing part of the furnace water wall below the furnace exit with wall superheater is the most viable and economic boiler modification design. A three-dimensional computational fluid dynamics (CFD) simulation was then conducted for a typical 320 MW subcritical boiler design to verify the feasibility of this design and determine the area of furnace wall that needs to be modified to achieve the target steam temperatures. The results show that with only 3.6 m height of furnace wall replaced with wall superheater both the superheat and reheat steam temperatures can reach the target 600 °C level even without any modification made to the reheaters. With this heating surface modification design, the efficiency of the existing subcritical power plants can be improved considerably with minimum boiler retrofit work. More importantly, this technology is going to help the plant owners meet the increasingly stringent efficiency and emission regulations mandated by the government and place them in a better position to continue operating these units.

DESIGN AND OPERATION OF RETROFITTING CHAIN-GRATE BOILER INTO A CFB BOILER

ANALYSIS OF RETROFITTING SCHEME FOR A COMBINED CYCLE WITH BOILER USING EXHAUST GAS FOR SUPPORTING COMBUSTION

Retrofitting of a Planar Separator Circulating Fluidized Bed Boiler

Retrofitting Technique of 65t/h Pulverized Coal-fired Boiler and Its Operation Performances

Retrofitting Strategy and Operating Technology of Pure Burning Zhundong Coal in a 135 MW Circulating Fluidized Bed Boiler

Retrofitting of 75 t/h tower type circulating fiuidized bed combustion boiler

Numerical Study and Hydrodynamic Calculation of the Feasibility of Retrofitting Tangentially Fired Boilers into Slag-Tap Boilers

Theoretical Analysis about Boiler Retrofit to Burn CWS

Feasibility Study on Substitution of Coal for Petrol Coke Fired in a CFB Boiler

Design and Operation of Large Size Circulating Fluidized Bed Boiler Fired Slurry and Gangue

Numerical Simulation about Retrofit Proposal to Reduce the Slagging of a 220 T/h Boiler

TECHNOLOGY OF RETROFITTING DESIGNED 220 T/h OIL-FIRED BOILER INTO COAL-WATER-SLURRY FIRED ONE AND APPLICATION THEREOF

Retrofit Scheme of a 75 T/h Circulating Fluidized Bed Boiler with Two-stage Window Blind Seperator

Design and Research on a 600MWe Supercritical Circulating Fluidized Bed Boiler

Design and operation of a MSW and straw Co-firing CFB boiler

Optimization of Fluidization State of a Circulating Fluidized Bed Boiler for Economical Operation

Operational Performance and Optimization of A 465t/h Cfb Boiler in China

Design and Operation of a 20 t/h Circulating Fluidized Bed Boiler System Burning Coal Slime

Analytical and numerical investigations on the high temperature upgrading solution of subcritical boilers

Calculation method for the determination of optimum recycle rate of CFB boiler in its design and operation

Nunerrical simulation analysis for economizing energy retrofit on type 10t/h spreader stoker boiler