Abstract:This paper presents characterization and compensation of the thermal bias drift of a MEMS accelerometer whose effective stiffness is electrostatically tuned to a low value with the help of the single-sided parallel plates (SSPPs) capacitors. A temperature drift model for the proposed accelerometer is built and the temperature effect on the mechanical stiffness and the circuit gains is characterized. The characterization reveals that the variations of the feedforward coefficient including the mechanical stiffness and the readout gain due to the temperature change play a significant role in the bias drift of output of the proposed closed-loop accelerometer. On the other hand, the variations of both feedback gain and tuning gain as a function of temperature are one-order-of-magnitude less than that of the feedforward coefficient. To calibrate the feedforward coefficient, an excitation signal as a form of AC reference displacement is introduced to drive the proof mass and the readout response is demodulated to calibrate the variance of the feedforward coefficient correspondingly. An open-loop compensation scheme for the temperature-induced bias drift using the variance of the calibrated response is proposed accordingly. Alternatively, the calibrated response can be controlled to a preset value by a new proportion integral derivative (PID) controller by the adjustment of the SSPP tuning voltage. The output of the PID controller is used for the calibration of the introduced bias from the electrostatic tuning force. Therefore, a closed-loop compensation of the thermal bias drift is achieved by remaining the feedforward coefficient while eliminating the calibrated bias. Experiments under a temperature cooling process and different tuning voltages are carried out to verify two proposed compensation schemes. The temperature drift coefficients (TDCs) of both compensated outputs exhibit at least one-order-of-magnitude reduction in response to the temperature change. When the effective stiffness of the accelerometer is tuned to about 4.19 N m(-1), the TDC of the compensated output using the proposed open-loop or closed-loop compensation schemes is reduced to about 0.1136 or 0.0391 mg degrees C-1, respectively and meanwhile, the Allan bias instability is slightly increased to 48.63 or 56.14 mu g, respectively.

Mechanism and suppression method for feedback-caused close-loop position fluctuation of electrostatically suspended accelerometer

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Design Of The Closed-Loop Capacitive Micro-Accelerometer Based On Pspice

Noise Behaviors of a Closed-Loop Micro-Electromechanical System Capacitive Accelerometer

Characterization and Compensation of Thermal Bias Drift of a Stiffness-Tunable MEMS Accelerometer

Identification and adjustment of the position and attitude for the electrostatic accelerometer's proof mass

Study on the Method of Charge Accumulation Suppression of Electrostatic Suspended Accelerometer

A Ground-Based Electrostatically Suspended Accelerometer

Weak closed-loop adjusting of wide-range micro-machined accelerometer's nonlinearity

Measuring Principle and Dynamic Characteristics Design for An Electro-Statically Suspended Accelerometer with Differential-Capacitance

Design and experiment of the detection circuit for electrostatically levitated accelerometers

Analysis and Prevention for Oscillation Failure of Capacitive Micro-Accelerometers

A New Structure of Test Mass for Ground-used Electrostatically Suspended Accelerometer

Closed-Loop Control and Output Stability Analysis of a Micromechanical Resonant Accelerometer

Study on suspension technique of space electrostatic accelerometer

EFFECT OF NON-PARALLEL PLATES OF FEEDBACK-BALANCED MICRO ACCELEROMETER ON RELIABLE OPERATION RANGE

Investigation of Drift Phenomena in Closed-Loop Capacitive Micro Accelerometers

Noise Analysis and In Situ Detection of the Electromagnetic Servo Actuator for a Nano-g Accelerometer With a Large Dynamic Range

Experiment Study of a Tri-Axis Electrostatically Suspended Micromachined Accelerometer

A Modulated Feedback Approach to Improve Closed Loop MEMS Accelerometer Bias Instability

Combined Temperature Compensation Method for Closed-Loop Microelectromechanical System Capacitive Accelerometer