Abstract:This paper proposes a new type of fabricated shear wall system, that is, the two ends of the horizontally distributed ribs and the top of the vertical distributed ribs are reliably connected with the cast-in-situ belt, and the bottom of the vertical distributed ribs is not penetrated and only connected by mortar. To study the seismic performance of the new wall, 7 specimens of the shear wall were designed and manufactured, including 2 cast-in-place shear walls and 5 new fabricated shear walls. Through low-cycle reciprocating loading tests, different analyses were made. Shear span ratio and different edge restraint structure of the new fabricated shear wall failure mode, bearing capacity and other seismic performance, and through OpenSees finite element analysis of the wall to verify the correctness of the modelling method. The test results show that the failure characteristics of the new wall are mainly the cracking and penetration of the mortar layer, the crushing of the corner concrete and the local buckling of the steel bars at the bottom of the edge members; compared with the cast-in-place wall, the new wall has the lower bearing capacity, but the deformation and energy consumption are not much different. The reinforced edge members can effectively compensate for the weakening of the integrity of the wall panel caused by the discontinuity of vertical steel bars. Among the 7 specimens, the overall performance of the wall with increased longitudinal reinforcement ratio is the best. The error between the wall finite element results and the test results is less than 5%, which shows that the modelling method in this paper has sufficient accuracy for the evaluation of the seismic performance of the new wall. In general, the new prefabricated shear wall system is feasible in high-rise buildings.

Analysis of an example of old masonry residence strengthenedby external prefabricated reinforced concrete shear walls

Seismic Performance of Reinforced Concrete Squat Walls with Embedded Cold-Formed and Thin Walled Steel Truss

Experimental Study on Both Sides Strengthening of Low-reinforced Shear Wall

Theoretical analysis and shaking table tests of old masonry structure reinforced by external frames with added stories on the top using seismic isolation technology

Quasi-Static Test of Reinforced Concrete Shear Wall with Low Concrete Strength and Reinforcement Ratio

Experimental study of reinforced concrete shear wall structure with low reinforcement ratio retrofitted by exterior strengthening method

In-Plane Strengthening Effect of Prefabricated Concrete Walls on Masonry Structures: Shaking Table Test

Earthquake resistant behavior on seismic strengthening of typical rural brick-wood structure in Beijing

Experimental study on seismic performance of new-type fabricated shear wall with mortar connection

Study on seismic performance of reinforced concrete shear wall with diagonally distributed reinforcement

Seismic performance of innovative prefabricated reinforced recycled concrete shear walls

Pseudo-dynamic Tests on Masonry Residential Buildings Seismically Retrofitted by Precast Steel Reinforced Concrete Walls

Experimental and Numerical Study on the Seismic Performance of Prefabricated Reinforced Masonry Shear Walls

EXPERIMENTAL STUDY OF A MASONRY BUILDING RETROFITTED INTEGRALLY BY PRE-FABRICATED RC PANELS

Study on the Seismic Performance of Frame-shear Wall Structures with High-strength Reinforced the Shear Wall

Experimental Study on Low Strength Brick Masonry Wall Strengthened with Self-compacting Concrete Wall

Seismic appraisal and strengthening design of a brick-frame mixed structure

Numerical Study on the Seismic Performance of Cold-Formed Steel Shear Walls with Steel Sheathing and Gypsum Board

Seismic performance of shear-critical prefabricated reinforced masonry shear walls with innovative vertical joint connections

Seismic performance of repaired prefabricated shear walls

Experimental study on seismic performance of T‐shaped partly precast reinforced concrete shear wall with grouting sleeves