Abstract:This paper proposes a new type of fabricated shear wall system, that is, the two ends of the horizontally distributed ribs and the top of the vertical distributed ribs are reliably connected with the cast-in-situ belt, and the bottom of the vertical distributed ribs is not penetrated and only connected by mortar. To study the seismic performance of the new wall, 7 specimens of the shear wall were designed and manufactured, including 2 cast-in-place shear walls and 5 new fabricated shear walls. Through low-cycle reciprocating loading tests, different analyses were made. Shear span ratio and different edge restraint structure of the new fabricated shear wall failure mode, bearing capacity and other seismic performance, and through OpenSees finite element analysis of the wall to verify the correctness of the modelling method. The test results show that the failure characteristics of the new wall are mainly the cracking and penetration of the mortar layer, the crushing of the corner concrete and the local buckling of the steel bars at the bottom of the edge members; compared with the cast-in-place wall, the new wall has the lower bearing capacity, but the deformation and energy consumption are not much different. The reinforced edge members can effectively compensate for the weakening of the integrity of the wall panel caused by the discontinuity of vertical steel bars. Among the 7 specimens, the overall performance of the wall with increased longitudinal reinforcement ratio is the best. The error between the wall finite element results and the test results is less than 5%, which shows that the modelling method in this paper has sufficient accuracy for the evaluation of the seismic performance of the new wall. In general, the new prefabricated shear wall system is feasible in high-rise buildings.

Experimental Study on Both Sides Strengthening of Low-reinforced Shear Wall

Quasi-Static Test of Reinforced Concrete Shear Wall with Low Concrete Strength and Reinforcement Ratio

Experimental study of reinforced concrete shear wall structure with low reinforcement ratio retrofitted by exterior strengthening method

Analysis of an example of old masonry residence strengthenedby external prefabricated reinforced concrete shear walls

Experimental study and FEM analysis on seismic behavior of a three-storied structural wall

Experimental Research on Seismic Behavior of Low Shear-Span Ratio Composite Shear Wall with Double Steel Plates and Infill Concrete

Experimental Study of Shear-Critical Reinforced-Concrete Shear Walls under Tension-Bending Shear-Combined Cyclic Load

Experimental Study on the Seismic Behavior of a Frame-Supported Reinforced Masonry Short-Limb Shear Wall Structure

Experimental and numerical investigation on the seismic behaviors of RC shear walls with multiple post-openings before and after strengthening by steel plates

Experimental Study on Low Strength Brick Masonry Wall Strengthened with Self-compacting Concrete Wall

Experimental Analysis of Seismic Performance of Strengthening Frame-supported Reinforced Concrete Masonry Short-leg Shear Wall Structure Damaged by Earthquake Using the Sub-structure Pseudo-dynamic Test

Experimental study on seismic performance of new-type fabricated shear wall with mortar connection

In-Plane Strengthening Effect of Prefabricated Concrete Walls on Masonry Structures: Shaking Table Test

Experimental study on the seismic performance of longitudinal wall between windows of brick-concrete school building

Study on seismic performance of reinforced concrete shear wall with diagonally distributed reinforcement

Earthquake resistant behavior on seismic strengthening of typical rural brick-wood structure in Beijing

Coupled Axial Tension-Shear Behavior of Reinforced Concrete Walls

Research advances of composite shear walls with double steel plates and filled concrete

An experimental study of the seismic behaviour of precast concrete shear walls with bolted-plate connections

EXPERIMENTAL STUDY ON SHEAR BEHAVIORS OF COLD-FORMED THIN-WALLED STEEL REINFORCED CONCRETE SHEAR WALLS WITH DIFFERENT DETAILS

Experimental Validation on Seismic Performance of a Monolithic Precast RC Shear Wall Structure with Novel Connections