Abstract:High-strength bolted connections have attracted increasing attention over the past few decades because they can safely transfer the design load. However, the effect of the preload loss on the mechanical behavior of the bolted connections has not been investigated sufficiently, This paper presents an experimental investigation of the bearing capacity of high-strength bolted connections with loose bolts (lacking pretension force). The tests investigated ninety specimens with loose bolts and six specimens without loose bolts for comparison. The results showed that bolt fracture was the only failure mode for all of the tested connections under uniaxial tension. The global behavior of the tested connections exhibited four stages, and the features of each stage were summarized. The connections with different tightening conditions exhibited a similar trend in terms of strain development around the bolt holes. The effect of the slip coefficient, position and number of loose bolts, and the plate thickness is elucidated through parametric studies. It is found that the yield load of high-strength bolted connections may be affected by the pretension force and the slip coefficient, while the effect of the slip coefficient gradually decreases with the increasing number of loose bolts. The experimental results are compared to the calculated ultimate bearing resistance according to the GB 50017, Eurocode 3, and AISC 360-16 standards. It is found that the resistance prediction of the standards may be too conservative for the prediction of the ultimate bearing capacity of loose high-strength bolted connections when bolt fracture governs failure. Practical design recommendations in the algebraic form are presented and verified to predict the yield load and ultimate bearing capacity of loose high-strength bolted connections.

RESEARCH ON THE BEARING CAPACITY OF WELD REINFORCED COMBINED CONNECTIONS WITH BOLTS AND WELDS IN STEEL STRUCTURE

Experimental study on the steel tube moment connections with modified cover-plated reinforcement

Experimental study on reinforcing moment connections for square steel tubes in National Swimming Center

Mechanical Behavior of Loose High-Strength Bolted Connections with Thin Sheet Steels

Study on the Combined Connections with Bolts and Welds in Reinforcement in Steel Structure

Experimental Research on Seismic Behavior of Reinforced Concrete Column-to-Steel Beam Joints with Bolted End-plate

Discussion on Influence of High Strength Bolt’s Parameters on the Weld Reinforced Combined Connection with Bolts and Welds

FINITE ELEMENT ANALYSIS OF THE LOADING CAPACITY OF CO-USE OF WELD AND BOLTS JOINT FOR REINFORCEMENT

Finite Element Analysis on the Bearing Capacity for Connection of Sharing on a Shear Load by Friction-Type High-Strength Bolts and Side Welds

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

Experimental Research on End-plate Bolted Connection with Steel Beam and Reinforced Concrete Column

Experiment of welding reinforcement of end-plate connection nodes in steel-structure under loads

Finite Element Analysis of the Combined Connection with Bolts and Welds

Investigation of the Tensile Properties of High-Strength Bolted Joints in Static Drill Rooted Nodular Piles

PROPOSED DESIGN METHOD OF COMBINED CONNECTIONS WITH BOLTS AND LONGITUDINAL WELDS FOR STEEL STRUCTURES

Finite Element Analysis of the Influence of Weld Size on the Combined Connection with Bolts and Welds

Investigations and proposed design rules on bolted connections for high strength steel

Analysis on Mechanical Properties of Bolt Connector under Reinforcement Binding and Welding Conditions Considering Flexural-shear Ratio

EXPERIMENTAL STUDY ON HIGH STRENGTH STEEL-PLATEBOLTED CONNECTIONS UNDER SHEAR FORCE

Study on the seismic behavior of connection via welding strengthening under load

Behavior of I-section Steel Beam Welding Reinforced While under Load