Abstract:This study is focused on the leakage flow rate of high-energy fluid passing through narrow elliptical slits with large aspect ratios, which is an issue in the application of the leak-before-break concept. Experiments were conducted using a high-temperature and high-pressure experimental platform at Xi'an Jiaotong University, where the temperature reached up to 320 degrees C and the pressure reached up to 10 MPa. These temperatures and pressures encompass a wide range of operating conditions (single-phase cold water, liquid-vapor (two-phase) mixture, and superheated steam). A series of narrow elliptical slits with different aspect ratios (528-2083) and hydraulic diameters (226-412 um) were used in the experiments. During the experiments, deionized water with a high flow rate (up to 4.5 t/h) was heated for different inlet conditions and the fluid was ejected through the narrow elliptical slits, followed by recovery in a spray chamber under atmospheric pressure. The real-time flow rate was measured as the leakage flow rate in these operating conditions. The experimental results for the subcooled water and two-phase regions were compared with Henry's homogeneous non-equilibrium model, whereas the results for the superheated steam region were compared with Yang's one-dimensional choked flow model. The experimental results indicate that Henry's homogeneous nonequilibrium model can be used to predict the leakage flow rate of fluid passing through narrow elliptical slits in the subcooled region; however, there are significant deviations between the computed and experimental leakage flow rates for the two-phase region. On the other hand, Yang's choked flow model can be used to predict the leakage flow rate of fluid passing through narrow elliptical slits with large aspect ratios. Based on the experimental data, the mathematical model for the two-phase mixture was corrected, and the results obtained from the modified model conform well with the experimental results.

Effect of Upstream Parameters on Two-Phase Critical Flow Leakage Characteristics

Experimental Study on the Flow and Thermal Characteristics of Two-Phase Leakage Through Micro Crack

Critical Mass Flux of Subcooled Liquid Leakage in a Nuclear Plant

Leak Rates of High Pressure Steam–water Across Simulation Crack

Critical flow leakage of a vapour-liquid mixture from sub-cooled water: Nucleation boiling study

Experimental study on leakage of high-energy fluids through narrow elliptical slits

Numerical Simulation of Micro-Crack Leakage on Steam Generator Heat Transfer Tube

Mass Transfer Characteristics of Pipeline Leak-Before-break in a Nuclear Power Station

A Non-Equilibrium Phase Change Model Based on the Lee Model for Flashing Flows in Converging–diverging Nozzles

LBB Leak Rate Calculation and Thermodynamic Non-equilibrium Effect Evaluation

Experimental and Theoretical Study on Fluid-Structure Interaction and Non-Equilibrium of the Flow Through Micro Cracks

Characteristic of Vapor Leakage Behavior from a Pressurized Pipeline System: Experiment and Model Study

Development of Leak Rate Model for Helium Flow in Elliptically Converging Through Wall Crack

Parameter Study for Critical Heat Flux under External Reactor Vessel Cooling Condition Based on a Mechanism Model

CFD modelling of flashing flows for nuclear safety analysis: possibilities and challenges

Experimental investigation and a mechanical model of critical heat flux in a narrow rectangular channel

Effect of Upstream Slot Leakage on Turbine Endwall Film Cooling Characteristics

A Prediction of the Leakage Through Cracks for Leak Before Break

Evaluation of Passive Circulation Flow Characteristics and Chf under In-Vessel Retention

Theoretical analysis of the characteristics of critical heat flux in vertical narrow rectangular channels under motion conditions

Numerical Study on the Thermal-Hydraulic Characteristics of the Choked Flow Through Micro Cracks for Various Conditions