Abstract:Leak-before-break analyses on tube microcracks are beneficial for preventing small loss of coolant accident in nuclear power plants. Specially, the tube leakage of steam generator may lead to steam generator tube rupture. Currently, experimental investigations on leak flow rate characteristics of normal temperature water and high pressure subcooled water through axial and circumferential microcracks of steam generator tubes were carried out, respectively. Cold Test results indicate that leak flow rates of circumferential microcracks for 0.13 <= W <= 0.16 mm and 3.6 <= delta/D-h <= 4.4 increase with a decreasing back pressure (P-out) first and then can be regarded as a constant value for a given working pressure in steam generator tubes (P-in). Additionally, each of Pin has a critical differential pressure between P-in and P-out (Lambda P-c). The ratio of Lambda P-c to P-in is equal to 0.55, which is smaller than 0.64 for axial microcracks. Hot Test results show that leak flow rates decrease significantly with an increasing working fluid temperature (T-f, in) when T-f, in is larger than a certain value due to the flashing of subcooled water near exits of microcracks. Besides, discharge coefficients of high pressure subcooled water through axial and circumferential microcracks under various back pressure conditions decreases with an increasing P-in for a given subcooled temperature. In general, new correlations were developed to give excellent predictions for the leak flow rate data of normal temperature water and high pressure subcooled water through axial and circumferential microcracks of steam generator tubes under various back pressure conditions with a maximum deviation of +/- 6%. (C) 2020 Elsevier Ltd. All rights reserved.

Mass Transfer Characteristics of Pipeline Leak-Before-break in a Nuclear Power Station

Critical Mass Flux of Subcooled Liquid Leakage in a Nuclear Plant

Evaluation of Blast Wave from Hydrogen Pipeline Burst by a Coupled Fluid-Structure-rupture Approach

A Numerical Study on the High-Velocity Impact Behavior of Pressure Pipes

Experimental Study on the Flow and Thermal Characteristics of Two-Phase Leakage Through Micro Crack

Effect of Upstream Parameters on Two-Phase Critical Flow Leakage Characteristics

LBB Leak Rate Calculation and Thermodynamic Non-equilibrium Effect Evaluation

Critical flow leakage of a vapour-liquid mixture from sub-cooled water: Nucleation boiling study

Characteristic of Vapor Leakage Behavior from a Pressurized Pipeline System: Experiment and Model Study

Leak Rates of High Pressure Steam–water Across Simulation Crack

The Flow and Heat Transfer Characteristics of Supercritical CO2 Leakage from a Pipeline

Study on Leak Rate of Gas Medium in Leak-Before-Break Technique-Ii: Theoretical Studies

Experimental Study on Leak Flow Rate Characteristics of High Pressure Subcooled Water Through Axial and Circumferential Microcracks of Steam Generator Tubes under High Back Pressure Conditions

Prediction of Leakage from Through Pipeline Crack

A Simplified Leak-Before-break Analysis Method of Pressured Pipes

A Study of Small-Scale CO 2 Accidental Release in Near-Field from a Pressurized Pipeline

A Comprehensive Review of the Leak Flow Through Micro-Cracks (in LBB) for Nuclear System: Morphologies and Thermal-Hydraulic Characteristics

A Modelling Study of the Multiphase Leakage Flow from Pressurised CO2 Pipeline.

A Prediction of the Leakage Through Cracks for Leak Before Break

Numerical Investigation of the Leakage Flow from a Pressurized CO2 Pipeline

Leakage characteristics of plug flow in the case of pipe leakage