Abstract:In general, only in tangential direction, friction motion between blade dampers is concerned for vibration analysis of mistuned bladed disk. However, in practical, excitation acting on blades inevitably causes normal movement at friction interface due to the existence of angle between excitation force and contact surface. This fact leads to a variation of normal force or even a result of contact separation, which determine the maximum static friction for tangential frictional vibration. In order to assess the realistic nonlinear forced vibration of mistuned disk assemblies subjected to actual excitation with nonlinear friction and contact, an efficient method is developed by using large-scale finite element model and two-dimensional friction model. In the proposed paper, attentions are paid on the realistic coupled vibration and the impact of variable normal vibration on forced response to a traveling wave excitation. Three types of mistuned parameters, including tangential stiffness of friction surface, initial shroud gap (corresponding to preload normal force), and structural stiffness of blades are taken into account for analyzing the effect of mistuning on the coupling vibration, especially for cases of contact separation. Furthermore, by means of curve fitting of amplitude variation of normal forces, the dependence of friction motion of bladed disk studied at circumferential resonance on variation of axial displacement, even with contact separation involved, is addressed. The results show a complex nonlinear vibration with friction and contact, especially a complex multiple unstable vibration observed with repeated nonlinear snap at circumferential resonance for the cases of contact separation. With regard to a small initial normal force, a large amplitude value of force variation can greatly reduce the maximum response amplitude for mistuned blades, which is worth to pay attentions for the vibration analysis of bladed disk with nonlinear friction and contact.

The Mechanism on Prediction of Transient Maximum Amplitude for Tuned and Mistuned Blisks

Advancing Mistuning Identification and Dynamic Modeling of Blisks Through Blade Detuning Tests

Vibration response prediction of coated blisks under multi-point non-contact excitations using mistuning identification data

The Amplification of Vibration Response Levels of Mistuned Bladed Disks: Its Consequences and Its Distribution in Specific Situations

Nonlinear Dynamics Analysis Of Mistuned Turbine Bladed Disks With Damped Shrouds

Investigation on the Vibration Localization of Mistuned Bladed Disk with Frictional Contact

A Reduced Order Approach for the Vibration of Mistuned Bladed Disk Assemblies

Transient Flutter Stability Analysis of Structural Mistuned Blisk by Energy Growth Method

Vibrational Response Analysis of Rotating Mistuned Bladed-Disk Using a Deconvolution Method Based on Blade Tip Timing

Reduced Order Models and Coupling Characteristics of the Mistuned Blade-Disk-Shaft Integration Rotor

Investigation on the parameter sensitivity of bladed assemblies undergoing mistuning features

Intentional blade mistuning to emulate the dynamic influence of split ring damper

Predictive dynamic modeling and analysis of blisks through digital representations constructed upon precise geometry measurements

Application of the hard-coating damper on the mistuned blisk for passive vibration reduction

Combinatorial Optimization of Mistuned Blade Rearrangement Based on Reduced-Order FEA Model

Dynamic characteristics of mistuned bladed disk system under rub-impact force

Reduced Order Modeling and Vibration Analysis of Mistuned Bladed Disk Assemblies With Shrouds

Vibration Analysis of Mistuned Damped Blades with Nonlinear Friction and Contact

Rapid Investigation of Blisk Mistuning Via Piezoelectric-Induced Stiffness Perturbations

Vibration Characteristics Investigation of Hard-Coated Mistuned Blisk With Multi-Packets By Lumped Parameter Model

Multi-mode vibration attenuation of mistuned bladed disks by frictional tuned mass dampers array