Abstract:In general, only in tangential direction, friction motion between blade dampers is concerned for vibration analysis of mistuned bladed disk. However, in practical, excitation acting on blades inevitably causes normal movement at friction interface due to the existence of angle between excitation force and contact surface. This fact leads to a variation of normal force or even a result of contact separation, which determine the maximum static friction for tangential frictional vibration. In order to assess the realistic nonlinear forced vibration of mistuned disk assemblies subjected to actual excitation with nonlinear friction and contact, an efficient method is developed by using large-scale finite element model and two-dimensional friction model. In the proposed paper, attentions are paid on the realistic coupled vibration and the impact of variable normal vibration on forced response to a traveling wave excitation. Three types of mistuned parameters, including tangential stiffness of friction surface, initial shroud gap (corresponding to preload normal force), and structural stiffness of blades are taken into account for analyzing the effect of mistuning on the coupling vibration, especially for cases of contact separation. Furthermore, by means of curve fitting of amplitude variation of normal forces, the dependence of friction motion of bladed disk studied at circumferential resonance on variation of axial displacement, even with contact separation involved, is addressed. The results show a complex nonlinear vibration with friction and contact, especially a complex multiple unstable vibration observed with repeated nonlinear snap at circumferential resonance for the cases of contact separation. With regard to a small initial normal force, a large amplitude value of force variation can greatly reduce the maximum response amplitude for mistuned blades, which is worth to pay attentions for the vibration analysis of bladed disk with nonlinear friction and contact.

Intentional blade mistuning to emulate the dynamic influence of split ring damper

Multi-mode vibration attenuation of mistuned bladed disks by frictional tuned mass dampers array

Application of the hard-coating damper on the mistuned blisk for passive vibration reduction

Advancing Mistuning Identification and Dynamic Modeling of Blisks Through Blade Detuning Tests

Nonlinear Dynamics Analysis Of Mistuned Turbine Bladed Disks With Damped Shrouds

Reduced Order Models and Coupling Characteristics of the Mistuned Blade-Disk-Shaft Integration Rotor

A Reduced Order Approach for the Vibration of Mistuned Bladed Disk Assemblies

Improving Aeroelastic Stability of Bladed Disks with Topologically Optimized Piezoelectric Materials and Intentionally Mistuned Shunt Capacitance

Reduced Order Modeling and Vibration Analysis of Mistuned Bladed Disk Assemblies With Shrouds

The Mechanism on Prediction of Transient Maximum Amplitude for Tuned and Mistuned Blisks

Combinatorial Optimization of Mistuned Blade Rearrangement Based on Reduced-Order FEA Model

Predictive dynamic modeling and analysis of blisks through digital representations constructed upon precise geometry measurements

Vibration Analysis of Mistuned Damped Blades with Nonlinear Friction and Contact

Tendon-inerter-damper helicopter blade augmentation for improved dynamic performance

Rapid Investigation of Blisk Mistuning Via Piezoelectric-Induced Stiffness Perturbations

A Disk-Type Magneto-Rheological Fluid Damper for Rotor System Vibration Control

A Disc-Type Magneto-Rheologtic Fluid Damper

A modeling method for a rotor system with an active floating ring squeeze film damper

Vibrational Response Analysis of Rotating Mistuned Bladed-Disk Using a Deconvolution Method Based on Blade Tip Timing

Investigation on the Vibration Localization of Mistuned Bladed Disk with Frictional Contact

Modelling and vibration evaluations of rotational mistuning-connecting disk-drum coupling structures with partial hard-coating damping treatment