Abstract:This paper presents a finite-element (FE) investigation on the bearing capacity of stainless steel hybrid tubular K-joints with square braces and circular chord. The nonlinear finite-element (FE) models were developed and validated against the test results available in the literature, which were then used to conduct a parametric study including 162 models. The parametric study results showed that the joint strengths of the stainless steel hybrid tubular gapped K-joints increased when the β and τ values increased and when the 2γ and e values decreased. On the other hand, the joint strengths of overlapped K-joints increased when the β, τ, and Ov values increased and when the 2γ values decreased. Furthermore, the bearing capacities obtained from the parametric study were compared with the design strengths calculated from the current design guidelines. The comparison showed that the current design rules of Chinese Code (GB 50017–2017) were generally un-conservative for stainless steel hybrid tubular K-joints. The coefficient of variations (COVs) obtained from the comparison of EC3 (2005), AS/NZS (2001) and GB 50017 (2017) were very large. However, the design strengths calculated from the International Committee for the Development and Study of Tubular Structures (CIDECT) were relatively close to the FE strengths. Therefore, modified design rules are proposed in this paper. New design formulas were developed by applying correction factors (ψg and ψo) to the current design rules of CIDECT (2008) for carbon steel CHS tubular K-joints, considering the effects of key geometric parameters of β, τ, 2γ and Ov, respectively. The proposed design rules can accurately predict the bearing capacity of stainless steel hybrid tubular K-joints with square braces and circular chord, being only 1% conservative to the FE strengths.

Representation of Nonlinear Behavior of Fully Grouted K Joints in Pushover Analysis

Fatigue Damage Development of Grouted Connection under Varying Cyclic Loading

AXIAL BEARING CAPACITY OF HIGH STRENGTH GROUTED CONNECTIONS WITH SHEAR KEYS

Experimental study of the static behavior of tubular N-joints

Property Analysis Of Grouted Clamping Tubular Joint For Offshore Platform Structures

Axial Bearing Capacity of Large-Diameter Grouted Connections Analyzed by Means of A Simplified Double Shear Test

Calculating the Nonlinear Stiffness and Ultimate Strength of Tube–Gusset Plate Joints in Circular Hollow Sections

An analytical model of longitudinal joints in the segmental lining of shield tunnels with considering geometric nonlinearity

Dynamic Behavior of Scaled Tubular K-joints Subjected to Impact Loads

Nonlinear behaviour and design of stainless steel hybrid tubular K-joints with SHS-to-CHS

FE analysis of composite tubular K-joints subjected to static loading

Numerical Analysis and Punching Shear Fracture Based Design of Longitudinal Plate to Concrete-Filled CHS Connections

EXPERIMENTAL AND NUMERICAL ANALYSIS ON THE K-JOINT LATERALLY IMPACTED BY A KNIFE EDGE INDENTER

08.40: Numerical Investigation of Mechanical Properties of Multi‐planar Concrete‐filled Steel Tubular Joints

Static behavior of stiffened CFST KK joints of offshore wind turbines under antisymmetric loading

Non-Linear Analysis of Ultimate Loading Capacity of Cast Tubular Y-Joints under Axial Loading

Experimental and Numerical Study on Ultimate Behaviour of High-Strength Steel Tubular K-joints with External Annular Steel Plates on Chord Circumference

An assessment of application of the component-based method to full range behaviour of joints between steel beam to concrete filled steel tube columns under extreme loading conditions

Experimental Study and Theoretical Analysis on the Ultimate Strength of High-Strength-steel Tubular K-Joints

An Analytical Solution for the Failure Process of a Shield Tunnel Segmental Joint with a Load-Transferring Gasket

Behaviour of Grouted Stainless Steel Tubular X-joints with CHS Chord under Axial Compression