Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

FE analysis of composite tubular K-joints subjected to static loading

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

Experimental study of the static behavior of tubular N-joints

EXPERIMENTAL INVESTIGATION AND NONLINEAR FINITE ELEMENT ANALYSIS ON THE BEHAVIOR OF CONCRETE-FILLED SQUARE STEEL TUBULAR COLUMN CONNECTIONS

ANALYTICAL BEHAVIOUR OF CONCRETE-FILLED STEEL TUBULAR K-JOINT USING STAINLESS STEEL

Behaviour Of Concrete-Filled Tubular T-Joints Under In-Plane Bending Cyclic Loading

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Concrete-Filled Steel and Steel Tubular T-Joints under Cyclic In-Plane Bending

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Design of concrete filled tubular CHS T-joints under in-plane bending

Mechanism of Load Introduction and Transfer Within Steel-Encased Concrete-Filled Steel Tube Connections

Mechanical Behaviour and Design of Concrete-Filled K and KK CHS Connections

FLEXURAL BEHAVIOUR OF THIN-WALLED DODECAGONAL SECTION DOUBLE SKIN CONCRETE-FILLED STEEL TUBES

Numerical Behaviour Of Composite K-Joints Subjected To Combined Loading And Corrosive Environment

Numerical Study of Hybrid Tubular K-joints with Circular Braces and Square Chord in Stainless Steel

Experimental and numerical study on static behaviour of uniplanar CFDST-CHS T-joints

Analytical Behaviour of CFDST Chord to CHS Brace Composite K-joints

Finite element analysis on static and dynamic performance of composite beam-to-column joint

Structural Analysis of Partially Concrete-filled and Welded Integral T-joints in Steel Truss Girders

Analytical behavior of circular concrete-filled thin-walled steel tubes subjected to bending

Experimental study of K-type joint of the concrete-filled rectangular steel tube truss