Abstract:Grouted sleeve connector is one of the most widely used connections in precast concrete structures. However, various defects may be introduced in the grouted sleeve connectors due to construction errors, which could significantly weaken their practical performance. In this study, 42 connectors were manufactured and tested under uniaxial tensile loading, where multiple grouting defects were considered (i.e. end defect, middle defect, anchor length defect, uniform defect, grouting density defect, thickness defect, horizontal defect, eccentric defect and grouting strength defect). First, the defect fabrication is examined by using the cone-beam computed tomography (CT) inspection system. Based on the tensile testing results, three failure modes including tensile fracture of reinforcing bar, anchor failure of the top reinforcing bar and anchor failure of the bottom reinforcing bar, could be observed. Besides, the decrease of the total effective anchor lengths of the bottom reinforcing bars could significantly lead to deterioration of the anchor properties and change the failure mode from fracture failure to anchor failure. For the specimens with end defect, when the defect length was longer than 42 mm, the connection performance deteriorated and the failure mode shifted from the tensile fracture of reinforcing bar to the anchor failure of reinforcing bar. Meanwhile, there was a significant correlation between the ultimate displacement and the failure mode, that is, the ultimate displacement of the anchorage failure specimens was generally less than that of the tensile fracture failure specimens. For connectors with the same total effective anchor lengths, discrete defects resulted in lower bearing capacity than concentrate defects, and when defects were farther away from the sleeve end, the bearing capacity is lower. That is, the lowest ultimate anchor strength was found in specimens with uniform defect, followed by specimens with middle defect and specimens with end defect. The presented work could be used for defect prevention and evaluation of grouted sleeve connectors.

Numerical Modeling of Grouted Connection Damage Development under Uniaxial Loading

Numerical Model of Cumulative Damage Evolution of Offshore Wind Turbine Grouted Connection under Cyclic Axial Load

Fatigue Damage Development of Grouted Connection under Varying Cyclic Loading

AXIAL BEARING CAPACITY OF HIGH STRENGTH GROUTED CONNECTIONS WITH SHEAR KEYS

Experimental study of the direct shear characteristics of cement grout under constant normal loading and stiffness boundary conditions

Axial Bearing Capacity of Large-Diameter Grouted Connections Analyzed by Means of A Simplified Double Shear Test

Numerical modelling on effect of loading rate on uplift behavior of suction caissons

Mechanical characteristics and damage model for rock-like specimen with two parallel grout-filled cracks

Research on bearing capacity of grouted connections under axial compression loads

Failure mechanism analysis and partial-interaction numerical simulation of Grouted Sleeve Connections (GSC) in tensile behavior

A fractional-order damage creep model for grouting-reinforcement body under dry–wet cycle

Numerical analysis on the mechanical response of grouted connection for pile-bucket foundation

Study of Grouting Reinforcement Mechanism in Fractured Rock Mass and Its Engineering Application

Experimental investigation on connection performance of fully-grouted sleeve connectors with various grouting defects

Experimental and theoretical model study on grouting reinforcement effect of fractured rock mass

A Three-Dimensional Grouting Model Considering Hydromechanical Coupling Based on the Combined Finite-Discrete Element Method

Research on Damage Evolution Law of Glazed Hollow Beads-Cement/Sodium Silicate Grouting Materials under Different Cycles of Loading and Unloading

Post-fire mechanical properties of full-grouted sleeve connection with different grouting defects

Influence analysis on the shear behaviour and failure mode of grout-filled jointed rock using 3D DEM coupled with the cohesive zone model

Experimental and numerical investigation of mixed mode fracture of high‐performance grouting materials based on peridynamics

Data-driven models for predicting tensile load capacity and failure mode of grouted splice sleeve connection