Abstract:In near-field electromagnetic links, the inductive voltage is usually much larger than the compliance of low-voltage integrated-circuit (IC) technologies used for the implementation of implantable devices. Thus most integrated power-recovery approaches limit the induced signal to low voltages with inefficient shunt regulation or voltage clipping. In this paper, we propose using high-voltage (HV) complementary metal-oxide semiconductor technology to fully integrate the inductive power and data-recovery front end while adopting a step-down approach where the inductive voltage is left free up to 20 or 50 V. The advantage is that excessive inductive power will translate to an additional charge that can be stored in a capacitor, instead of shunting to ground excessive current with voltage limiters. We report the design of two consecutive HV custom ICs-IC1 and IC2-fabricated in DALSA semiconductor C08G and C08E technologies, respectively, with a total silicon area (including pads) of 4 and 9 mm(2), respectively. Both ICs include HV rectification and regulation; however, IC2 includes two enhanced rectifier designs, a voltage-doubler, and a bridge rectifier, as well as data recovery. Postlayout simulations show that both IC2 rectifiers achieve more than 90% power efficiency at a 1-mA load and provide enough room for 12-V regulation at a 3-mA load and a maximum-available inductive power of 50 mW only. Successful measurement results show that HV regulators provide a stable 3.3- to 12-V supply from an unregulated input up to 50 or 20 V for IC1 and IC2, respectively, with performance that matches simulation results.

Digitally Assisted High-Voltage High-Current CMOS Active Rectifier for Implantable Devices

A Bootstrapped Switch Based Efficient CMOS Full-Wave Active Rectifier for Biomedical Implants

A VHF Wide-Input Range CMOS Passive Rectifier With Active Bias Tuning

A 13.56 MHz Efficient Active Rectifier with Quasi-Constant Delay Compensation Scheme for Implantable Medical Devices.

A 6.78 MHz, 95.0% Peak Efficiency Monolithic Two-Dimensional Calibrated Active Rectifier for Wirelessly Powered Implantable Biomedical Devices

A 200 MHz Passive Rectifier With Active-Static Hybrid V TH Compensation Obtaining 8% PCE Improvement

A 13.56 MHz pulse-width modulation active rectifier for implantable medical devices

A High Efficiency and High Power Density Active AC/DC Converter for Battery-Less US-Powered IMDs in a 28-nm CMOS Technology

A high-efficiency full-wave CMOS rectifying charge pump for RF energy harvesting applications

A 13.56MHz Wireless Power Transfer System with Dual-Output Regulated Active Rectifier for Implantable Medical Devices

Integrated ultra-low power precision rectifiers for implantable medical devices

Optimal Design of a Low-Power, Phase-Switching Modulator for Implantable Medical Applications.

A 6.78 MHz Maximum Efficiency Tracking Active Rectifier with Load Modulation Control for Wireless Power Transfer to Implantable Medical Devices

A High-Voltage-Compliant 86% Peak Efficiency Current-Mode Stimulator with Dynamic Voltage Supply for Implantable Medical Devices

A 900 MHz, Wide-Input Range, High-Efficiency, Differential CMOS Rectifier for Ambient Wireless Powering

Integrated High-Voltage Inductive Power and Data-Recovery Front End Dedicated to Implantable Devices

A Wireless Charging Circuit with High Power Efficiency and Security for Implantable Devices

A High-Efficiency, Low-Power Wireless Power and Data Frontend for Implantable Applications

2-20-V Wide Input Range Active Rectifier with Single-Multiplexing Adaptive Delay Compensation and Low-Voltage Enhancement for Wireless Power Transmission

A Hybrid Three Phase Current Source Rectifier For High Power Application

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier