Abstract:Nanoscale research has been an area of active research over the past fifteen years. This is due to the overall enhanced properties of nanomaterials due to size effects, surface effects, and interface effects, which typically showed up in materials with characteristic size smaller than 100 nm. This study focuses on the molecular dynamics (MD) simulation of an infinitely long, cylindrical platinum nanowire, with an approximate diameter of 1.4 nm. The nanowire was subjected to uniaxial tensile strain along the [001] axis. The changes in crystal structure during deformation were analyzed and its mechanical properties were deduced from the simulation. Classical MD simulation was employed in this study, with the empirical Sutton-Chen pair functional used to describe the interatomic potential between the platinum atoms. The Berendsen loose-coupling thermostat was selected for finite-temperature control of the simulated system, with a time constant of 25% of the total relaxation time during each strain increment. The nanowire was subjected to strain rates of 0.04%, 0.4%, and 4.0% ps(-1), at simulation temperatures of 50 and 300 K, in order to study the effects of different strain rates and thermal conditions on the deformation characteristics and mechanical properties of the nanowire. It was found that the stress-strain response of the nanowire showed clear periodic, stepwise dislocation-relaxation-recrystallization behavior at low temperature and strain rate, where crystal order and stability were highly preserved. The onset of amorphous crystal deformation occurred at 0.4% ps(-1), and fully amorphous deformation took place at 4.0% ps(-1), with amorphous melting detected at 300 K. Due to higher entropy of the nanowire at higher temperature and strain rate, periodic stress-strain behavior became less clearly defined, and superplasticity behavior was observed. This characteristic was significantly enhanced due to the development of a single-walled helical substructure at 300 K, when the nanowire was deformed at a lower strain rate. The Young's modulus was found to be about 50% to 75% that of its bulk counterpart, while the Poisson ratio was not significantly changed at the nanoscale.

Nanostrain Sensitivity in a Wire Torsion Experiment

In Situ Observation of High Bending Strain Recoverability in Au Nanowires

Deformation of Copper Nanowire under Coupled Tension–Torsion Loading

Influence of specimen dimensions and strain measurement methods on tensile stress–strain curves

Strong Hall-Petch Type Behavior in the Elastic Strain Limit of Nanotwinned Gold Nanowires

Characterizing Torsional Properties of Microwires Using an Automated Torsion Balance

In Situ Nanoscale Deformation Studies on Micro Copper Wires Using Atomic Force Microscopy

Toward A Further Understanding of Size Effects in the Torsion of Thin Metal Wires: an Experimental and Theoretical Assessment

Deformable and Wearable Carbon Nanotube Microwire-Based Sensors for Ultrasensitive Monitoring of Strain, Pressure and Torsion

Approaching the theoretical elastic strain limit in copper nanowires.

Experimental and computational study of the NiTi thin wires mechanical behavior

High Strain Rate Tensile Testing of Silver Nanowires: Rate-Dependent Brittle-to-Ductile Transition

Anomalous Plasticity in the Cyclic Torsion of Micron Scale Metallic Wires.

Molecular Dynamics Simulation Of A Solid Platinum Nanowire Under Uniaxial Tensile Strain: Temperature And Strain-Rate Effects

The Uniaxial Tensile Deformation of Ni Nanowire: Atomic-Scale Computer Simulations

Size Effects in the Torsion of Microscale Copper Wires: Experiment and Analysis

Atomistic Study Of The Mechanical Response Of Copper Nanowires Under Torsion

Size Effect in Stainless Steel Thin Wires under Tension

Quasicontinuum Simulation of Uniaxial Tension of Single Crystal Copper Nanowire

A High Sensitivity Single-Walled Carbon-Nanotube-array-based Strain Sensor for Weighing

An Atomistic Study of the Deformation Behavior of Tungsten Nanowires