Abstract:The effect of cold-drawing on the tensile property and giant magneto-impedance (GMI) effect of melt-extracted Co-based amorphous microwires was evaluated through detailed analyses of the distribution of residual stress and microstructural evolution. The tensile ductility and tensile strength increased gradually with cross-sectional area reduction ratio (R) until 51%, and decreased with further deformation. The microwire with R=51% exhibits the highest tensile ductility of 1.09% and tensile strength of 4320MPa. Structural and thermodynamic analyses reveal that it is the mechanical deformation rather than thermal activation that induces the precipitation of nanocrystals and arrests the quick extension of shear bands leading to the enhanced ductility. Interestingly, the GMI effect also attains the maximum value of 160% at 10MHz when R=51% (30% larger than that of the as-cast wires), before decreasing with further cold-drawing. Such an identical evolution trend of both tensile and GMI properties can be ascribed to two underlying mechanisms: the generation of longitudinal and circumferential residual stresses and the growth of deformation-induced nanocrystals during cold-drawing. The role of residual stress is established herein not only as a trigger to accelerate the amorphous-to-nanocrystalline phase transformation but also as a decisive contributor to the mechanical and GMI performance. The unique simultaneous improvement of both mechanical and GMI properties of cold-drawn Co-based microwires opens up new possibilities for a variety of engineering applications, such as high-performance magnetic, stress and biological sensors.

Characterizing Torsional Properties of Microwires Using an Automated Torsion Balance

A New Torsion Tester Based on an Electronic Autocollimator for Characterizing the Torsional Behaviors of Microfibers.

Direct measurement of torsional properties of single fibers

In Situ SEM Torsion Test of Metallic Glass Microwires Based on Micro Robotic Manipulation

Structural, Magnetic and Mechanical Properties of Oligocrystalline Ni-Mn-Ga Shape Memory Microwires

Size Effects in the Torsion of Microscale Copper Wires: Experiment and Analysis

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

Anomalous Plasticity in the Cyclic Torsion of Micron Scale Metallic Wires.

Toward A Further Understanding of Size Effects in the Torsion of Thin Metal Wires: an Experimental and Theoretical Assessment

A Novel Torsion Testing Technique for Micro-Scale Specimens Based on Electromagnetism

In Situ Microwave Characterization Of Microwire Composites Under Mechanical Stress

Size and Passivation Effects in the Torsion of Thin Metallic Wires

Nanostrain Sensitivity in a Wire Torsion Experiment

Atomistic Study Of The Mechanical Response Of Copper Nanowires Under Torsion

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

In Situ Micromechanical Characterization of Metallic Glass Microwires under Torsional Loading

Fracture Characteristics in Micron Molybdenum Wires under Cyclic Torsion Loading

Scale effect investigation of copper microwire's mechanical properties after in situ scanning electron microscope twisting

Instability of Soft Elastic Filaments under Torsion: Experiment and Analysis

Stress-Induced Magnetic Hysteresis in Amorphous Microwires Probed by Microwave Giant Magnetoimpedance Measurements

Design of a Novel Tensile Testing Device and Its Application in Tensile Testing Experiments on Copper Micro Wires