Abstract:Gelcasting is a new ceramic forming technology for making complex-shaped ceramic products with high performance. The processes used in gelcasting are similar to processes often used in conventional ceramic forming process. However, when new high performance materials are introduced with the aim to improve the strength, defects such as air bubbles or agglomerates that can be found in many traditional ceramic materials are no longer be allowed since this would reduce the performance and reliability of the final ceramic products. The aim of this thesis project was to find an appropriate recipe of the ceramic suspension meanwhile improving the process of gelcasting and obtaining ceramic products with excellent mechanical behavior. To achieve this specified target, alumina and zirconia powders were studied in the following experiments which included rheological measurement of viscosity and storage modulus measurement for ceramic suspensions and drying shrinkage measurement of cast materials. The binder was burned out and the density was measured for ceramic materials sintered at different temperatures. The mechanical strength of sintered materials with high density was evaluated and the microstructure of fracture surfaces of ceramic samples was studied. Through rheological measurement, a good balance between fluidity and solid content of ceramic suspension was found. For alumina suspensions a solid content of 55vol% was selected and for zirconia solid contents of 46, 48 and 50vol% were studied. A monomer was dissolved in the suspension and an initiator was added to facilitate the polymerization of the monomer when the temperature was increased to around 70oC. The failure analysis of the fractured bending bars showed that the defects that caused the failure were not air bubbles but agglomerates. As a result, in future research for ceramic gelcasting with the intention to improve the mechanical strength, the suggestion is to use an appropriate recipe for the ceramic suspension and focus on elimination of granules and agglomerates from the suspension

Development of ethylene glycol-based gelcasting for the preparation of highly porous SiC ceramics

Recent Developments in Gelcasting of Ceramics

Preparation of porous ceramics by gelcasting approach

Highly Porous LAS-SiC Ceramic with Near-Zero Thermal Expansion Prepared Via Aqueous Gel-Casting Combined with Adding Pore-Forming Agents

Gas-discharging Reactions in Gelcasting of Si-containing Materials and Their Effect on Microstructure of Green Bodies

Gel Casting of High Strength Ceramics

Gelcasting Preparation of Porous Silicon Nitride Ceramics by Adjusting the Content of Monomers

Gel-casting Without De-Airing Process Using Silica Sol As a Binder

Porous YSZ Ceramics by Water-Based Gelcasting

Gas-discharging reactions and their effect on the microstructures of green bodies in gelcasting of non-oxide materials

Preparation of HEMA gel-casted SiC ceramics combined with LPS sintering

Processing, Microstructures and Mechanical Properties of Aqueous Gelcasted and Solid-State-Sintered Porous Sic Ceramics

Improved Gelcasting

Suppression of Surface-Exfoliation by Gelcasting Ceramics with Mixed Polymer-Monomer Solutions

Formation of Silicon Nitride Bonded Silicon Carbide by Aqueous Gelcasting

Preparation of High Concentrated Suspension and Gelcasting Process for Silicon Nitride Bonded Silicon Carbide Refractories

Preparation of <i>In Situ</i> Synthesized SiC Particles Reinforced Highly Porous Si<sub>3</sub>N<sub>4</sub> Ceramics by Gel-Casting

Gelcasting of Concentrated Aqueous Silicon Carbide Suspension

Study of the Inhibitive Role of Polyethylene Glycol on the Surface-Exfoliation of Ceramic Green Bodies Prepared by Gelcasting

Porous α-Al2O3 ceramics prepared by gelcasting

Novel porous Si3N4 ceramics prepared by aqueous gelcasting using Si3N4 poly-hollow microspheres as pore-forming agent