Abstract:Phase change materials are used in passive solar house construction with light steel structure walls, which can overcome the problems of weak heat storage capacity and poor utilization of solar heat and effectively solve the thermal defects of light steel structure walls. Based on this, on the basis of preliminary experimental research, this study further carried out theoretical analysis and simulation research on the thermal performance of a light steel structure passive solar house (Trombe form) with PCM walls. Through the heat balance analysis of heat transfer in the heat collecting partition wall, the theoretical calculation formula of the phase change temperature of the PCM was obtained, and it verified theoretically that the phase change temperature value should be 1–3 °C higher than the target indoor air temperature. The evaluation index “accumulated daily indoor temperature offset value” was proposed for evaluating the effect of phase change materials on the indoor temperature of the passive solar house, and “EnergyPlus” software was used to study the influence of the phase change temperature, the amount of material, and the thickness of the insulation layer on the indoor air temperature in a natural day. The results showed that there was a coupling relationship among the performance and between of the thickness of the PCM layer and the phase change temperature. Under typical diurnal climate conditions in the northern Tibetan Plateau of China, the optimal combination of the phase change temperature and the layer thickness was 17 °C and 15 mm, respectively. Especially at a certain temperature, excessive increases in the thickness of the phase transition layer could not improve the indoor thermal environment. For this transition temperature, there exists an optimal transition layer thickness. For a Trombe solar house, the thickness of the insulation layer has an independent impact on indoor temperature compared to other factors, which has an economic value, such as 50 mm in this case. In general, this paper studied the relationship between several important parameters of the phase change wall of a solar house by using numerical simulation methods and quantitatively calculated the optimal parameters under typical meteorological conditions, thus providing a feasible simulation design method for similar engineering applications.

Experimental Study Of Thermal Effect Of Lacquer Coating For Pv-Trombe Wall System Combined With Phase Change Material In Summer

Experimental study on thermal performance of an integrated PCM Trombe wall

Numerical Study on Thermal Performance of PCM Trombe Wall

Numerical Investigations on Performance of Phase Change Material Trombe Wall in Building

Performance study of a phase change material Trombe wall system in summer in hot and humid area of China

Enhancing indoor thermal comfort and energy efficiency: A comparative study of RC-PCM Trombe wall performance

Study on the thermal performance of a new double layer PCM trombe wall with multiple phase change points

Effects of the PCM layer position on the comprehensive performance of a built-middle PV-Trombe wall system for building application in the heating season

Effects of the position and melting point of the PCM layer on the comprehensive thermal performance of a Trombe wall under mixed dry climate

Effect of key parameters on the transient thermal performance of a building envelope with Trombe wall containing phase change material

Investigation on heating performance of an integrated phase change material Trombe wall based on state space method

Coupling Optimization Study of Key Influencing Factors on PCM Trombe Wall for Year Thermal Management

Experimental Study on Heat Storage/Release Performances of Composite Phase Change Thermal Storage Heating Wallboards Based on Photovoltaic Electric-Thermal Systems

Thermal Performance Optimization Simulation Study of a Passive Solar House with a Light Steel Structure and Phase Change Walls

The Trombe Wall Equipped with PCMs for the Enhancement of the Indoor Thermal Quality

NUMERICAL STUDY ON THE PHOTO-THERMAL AND ELECTRICAL PERFORMANCE OF A NOVEL TROMBE WALL WITH PV CELLS

Experimental and Numerical Performance Analysis of an Active Cooling Wall Module Equipped with Micro-encapsulated Phase Change Material

Experimental Study and Performance Analysis on Solar Photovoltaic Panel Integrated with Phase Change Material

Performance analysis of a novel phase-change wall of wood structure coupled with sky-radiation cooling

Performance of PV-Trombe Wall in Winter Correlated with South Façade Design

Application of Phase Change Material in Improving Trombe Wall Efficiency: an Up-to-date and Comprehensive Overview