Abstract:The prefabricated temporary house (PTH) has been widely used in various scenarios because of its convenience and environmental protection. However, PTHs are usually lightweight buildings with weak thermal inertia, resulting in poor indoor thermal comfort. Numerical research was conducted on the potential of phase change materials (PCMs) as a passive alternative to enhance the performance of the PTH throughout the year in this study. The influences of some critical factors such as thickness, phase change temperature, ventilation, building orientation, and climatic region on the thermal characteristics of PTHs were evaluated. The thermal comfort hours and energy consumption were employed as indicators to quantify the influence of PCMs on the dynamic thermal performance of PTHs. The numerical results indicated that the thickness had different effects on the PTH in different climate regions. When the total thickness of the wall was constant, I-level thermal comfort hours of the PCM rooms were higher than those of the reference room. For the Beijing area, when the wall was composed of a 100 mm insulation board, the indoor I-level thermal comfort hours were 803 h, while when the wall was composed of 90 mm insulation boards and 10 mm PCM panels, the indoor I-level thermal comfort hours increased to 1511 h. Moreover, it was worth noting that the optimal PCMs for different building orientations were basically the same, but the optimal PCMs for the PTH with and without air conditioning were different. Ventilation significantly increased thermal comfort hours and reduced energy consumption for the PTH in Guangzhou, while a larger ventilation rate would reduce the thermal comfort hours of the PTH in Kunming. In general, the numerical results supported and highlighted the potential of integrating PCM in the PTH to enhance living comfort and reduce energy consumption.

The Trombe Wall Equipped with PCMs for the Enhancement of the Indoor Thermal Quality

Numerical Investigations on Performance of Phase Change Material Trombe Wall in Building

Enhancing indoor thermal comfort and energy efficiency: A comparative study of RC-PCM Trombe wall performance

Numerical Simulation on the Thermal Performance of a PCM-containing Ventilation System with a Continuous Change in Inlet Air Temperature

Study on the thermal performance of a new double layer PCM trombe wall with multiple phase change points

Numerical Study on Thermal Performance of PCM Trombe Wall

Effects of the position and melting point of the PCM layer on the comprehensive thermal performance of a Trombe wall under mixed dry climate

Effect of key parameters on the transient thermal performance of a building envelope with Trombe wall containing phase change material

Performance study of a phase change material Trombe wall system in summer in hot and humid area of China

Coupling Optimization Study of Key Influencing Factors on PCM Trombe Wall for Year Thermal Management

Investigation on heating performance of an integrated phase change material Trombe wall based on state space method

Performance of a Curved Corrugated Surface Trombe Wall Coupled Phase Change Material in Buildings by Numerical Models and Experiments

CFD Modeling and Experimental Validation of the Thermal Performance of a Novel Dynamic PCM Trombe Wall: Comparison with the Companion Static Wall with and Without PCM

Passive Application of PCMs for the Trombe Wall: a Review

Effects of the PCM layer position on the comprehensive performance of a built-middle PV-Trombe wall system for building application in the heating season

Parametric and Optimization Analyses of a Dynamic Trombe Wall Incorporating PCM to Save Heating Energy under Cold Climate Zones

Numerical simulations on the thermal performance of ventilated walls with passive solar heating and latent heat storage in winter

Thermal performance of a novel Trombe wall integrated with direct absorption solar collector based on phase change slurry in winter

Heating and Energy Performances of a Dynamic Trombe Wall Incorporating Phase Change Materials under Different Operation Modes

Improvement of Indoor Thermal Environment in Light Weight Building Combining Phase Change Material Wall and Night Ventilation

Numerical study on thermal comfort and energy-saving potential of a prefabricated temporary house integrated with composite phase change materials