Abstract:Over-the-air (OTA) testing and electromagnetic compatibility (EMC) measurements are widely performed in classical reverberation chambers. A less-known reverberation chamber, yet a considerably efficient environment for generating multipath conditions, is the vibrating intrinsic reverberation chamber (VIRC). This article thoroughly investigates the radio propagation channel inside the VIRC. The specific channels studied are narrowband single-input single-output (SISO) systems operating in the frequency range from 670–2740 MHz. A relevant application is OTA testing wireless baseband algorithms or modems for wireless sensor networks, specifically low-power wide-area networks such as Narrowband-IoT (NB-IoT), Long Range (LoRa) and Ultra-Narrowband (UNB). The focus is on the first- and second-order temporal and spectral channel characteristics: coherence time, Doppler spectrum, Doppler spread, frequency autocovariance function, coherence bandwidth, rejection rate of chi-squared goodness-of-fit test for Rician distribution, Rician -factor, and channel gain. Besides the impact of the frequency of operation, the investigation considers the effect of the rotational speed of the VIRC motors, two loading conditions, on the channel characteristics. An analysis of the measurement results shows that the stirring efficiency degrades while the coherence time increases at slow rotational speeds, with loading, and/or at low frequencies. Moreover, empirical models closely fitting the behavior of various investigated characteristics are proposed, for which we provide foundational physical interpretations. A further investigation is carried out to demonstrate the generality and briefly illustrate the potential usability of these models for both EMC and OTA testing.

Turn-Table Platform Stirring in Reverberation Chambers for OTA Applications

Reverberation Chamber Stirring Method Based on Phased Array Antenna and Frequency Stirring Techniques

Improving Field Uniformity Using Source Stirring with Orbital Angular Momentum Modes in a Reverberation Chamber

Empirical Characterization and Modeling of the Propagation Channel Inside the VIRC

Technology of the Reverberation Chamber for EMC Test

An Efficient Total Radiated Power Test Method Based on Optimal Interpolation over a Sphere of Large Antenna Array

Uncorrelated Configurations and Field Uniformity in Reverberation Chambers Stirred by Tunable Metasurfaces

A Fast Technique to Evaluate Uniformity Conformity to Standards' Requirement for a Reverberation Chamber at the Low End of Test Frequency

A Bridged Contactless Measurement Technique for LC Tank Based Voltage-Controlled Oscillator.

A Novel Mode-Stirred Reverberation Chamber Design for 5G Millimeter Wave Bands

Evaluation of the Split Stirrer in Reverberation Chamber

Calibration Test of Reverberation Chamber

Switchable Metasurface Absorber Used for Enabling Reconfigurable Power Angular Spectrum in Reverberation Chamber

A Review of Over-the-Air Testing Methods for Performance Measurement of Antennas and Devices in Communication Systems

Base station over-the-air testing in reverberation chamber

An Alternative Method to Identify the Susceptibility Threshold Level of Device under Test in a Reverberation Chamber

Key issues and algorithms of multiple-input-multiple-output over-the-air testing in the multi-probe anechoic chamber setup

Numerical Simulation Study of Ota Anechoic Chamber Ripple Quality

A Low-Cost and Efficient Single Probe Based MIMO OTA Measurement Method

Study of independent sampling points in a reverberation chamber with two stirrers

A Realisation of Channel Emulation in a Reverberation Chamber method for Over-the-Air Compliance Testing in Support of 3GPP Standardisation