Abstract:Over-the-air (OTA) testing and electromagnetic compatibility (EMC) measurements are widely performed in classical reverberation chambers. A less-known reverberation chamber, yet a considerably efficient environment for generating multipath conditions, is the vibrating intrinsic reverberation chamber (VIRC). This article thoroughly investigates the radio propagation channel inside the VIRC. The specific channels studied are narrowband single-input single-output (SISO) systems operating in the frequency range from 670–2740 MHz. A relevant application is OTA testing wireless baseband algorithms or modems for wireless sensor networks, specifically low-power wide-area networks such as Narrowband-IoT (NB-IoT), Long Range (LoRa) and Ultra-Narrowband (UNB). The focus is on the first- and second-order temporal and spectral channel characteristics: coherence time, Doppler spectrum, Doppler spread, frequency autocovariance function, coherence bandwidth, rejection rate of chi-squared goodness-of-fit test for Rician distribution, Rician -factor, and channel gain. Besides the impact of the frequency of operation, the investigation considers the effect of the rotational speed of the VIRC motors, two loading conditions, on the channel characteristics. An analysis of the measurement results shows that the stirring efficiency degrades while the coherence time increases at slow rotational speeds, with loading, and/or at low frequencies. Moreover, empirical models closely fitting the behavior of various investigated characteristics are proposed, for which we provide foundational physical interpretations. A further investigation is carried out to demonstrate the generality and briefly illustrate the potential usability of these models for both EMC and OTA testing.

Base station over-the-air testing in reverberation chamber

A Review of Over-the-Air Testing Methods for Performance Measurement of Antennas and Devices in Communication Systems

A Simple Over-The-Air Hardware Calibration Procedure In Tdd Systems

A Reverberation Chamber for Antenna Measurements up to 140 GHz

Evaluation Of Transmit Antenna Position In Reverberation Chamber

A Fast Technique to Evaluate Uniformity Conformity to Standards' Requirement for a Reverberation Chamber at the Low End of Test Frequency

Test Zone Validation for FR2 MPAC Using Directional Antenna Based Virtual Array

Empirical Characterization and Modeling of the Propagation Channel Inside the VIRC

Evaluation Of Test Reproducibility Of Calibration In Reverberation Chamber

Transmitting Antenna's Reflected Power and Its Influence on Reverberation Chamber Calibration

Testing Investigation of Antenna Calibration Factor and Insertion Loss of a Reverberation Chamber

Angular sampling, Test Signal, and Near Field Aspects for Over-the-Air Total Radiated Power Assessment in Anechoic Chambers

Calibration Test of Reverberation Chamber

A Realisation of Channel Emulation in a Reverberation Chamber method for Over-the-Air Compliance Testing in Support of 3GPP Standardisation

Whole-body SAR measurements of millimeter-wave base station in reverberation chambers

Over-the-Air Phase Calibration Methods for 5G mmW Antenna Array Transceivers

Experimental Investigation of 5G Base Station functionalities in Reverberation Chamber at Millimeter-Wave

Key issues and algorithms of multiple-input-multiple-output over-the-air testing in the multi-probe anechoic chamber setup

Field Uniformity Investigation Of Reverberation Chamber At Calibration Stage

Load Effect Investigation Of A Reverberation Chamber

Comparison on the Test Results Between Reverberation Chamber and Anechoic Chamber