Influences of Solution Temperature on Microstructures and Performance of Electron Beam Welded Joints of Laser Powder Bed Fusion TC11 Thin-Walled Samples
Feipeng An,Linjie Zhang,Jun Wu,Meng Wang,Miaoxia Xie
DOI: https://doi.org/10.1016/j.matchar.2024.113926
IF: 4.537
2024-01-01
Materials Characterization
Abstract:The effects of subtransus treatment (750 degrees C, 800 degrees C, 850 degrees C, 900 degrees C, and 950 degrees C) as well as supertransus treatment (1100 degrees C) on the microstructures and mechanical performance of electron beam welded (EBW) joints of laser powder bed fusion (LPBF) TC11 alloy were investigated. At a solution temperature of 950 degrees C, globular alpha phases and transformed beta phases were observed in the joint. When the solution temperature exceeded the beta transus temperature (T beta), alpha colonies and massive alpha phases emerged in the joints, resulting in Widmanstatten structures. The base metal (BM) exhibited the highest microhardness, followed by the heat affected zone (HAZ), whereas the fusion zone (FZ) demonstrated the lowest microhardness. As the solution temperature increases, the microhardness of joints decreases at first and then increases. Notably, the joint subjected to a solution temperature of 850 degrees C exhibited the lowest microhardness. When the solution temperature was >= 900 degrees C, transformed beta phases emerged within the joints, resulting in an elevation of microhardness. Below T beta , the elongation of welded joints gradually augmented while the tensile strength reduced at first and then increased with the rising solution temperature. Microstructures in joint with solution temperature of 950 degrees C consisted of lamellar alpha phases, globular alpha phases, and transformed beta phases. As a result, the joint exhibited an optimal balance between strength (1103.1 +/- 34.9 MPa) and plasticity (9.37 +/- 0.20%). Ductile fracture characteristics with dimples on the fracture surface were observed in the tensile samples. Therefore, it can be concluded that a solid solution temperature of 950 degrees C is optimal for LPBF TC11 alloy.