Abstract:Diamond micro/nano-pillar is widely applied in quantum transportation and nanomechanics, but it is very difficult to be machined by conventional mechanical methods, duo to its feature of high hardness, wear-proof and extremely small scale. Thus, a novel strategy of galvanometer-assisted femtosecond laser milling (GFM) was proposed to overcome the difficulty of fabricating the micro-pillar with high aspect ratio on monocrystalline diamond. Through numeric calculation, it is found that GFM trajectory possesses the special distribution consisting of separate pulse-concentrated regions and expanded flat-distributed region, which was then experimentally proved beneficial for improving the energy consumption and highly promoting the material removal rate. Moreover, the GFM was found to be much easier to generate micro-pillar, whereas in the case of conventional non-galvanometer milling (NGM) micro-pillar underwent severe degeneration or height loss under various average laser powers. Through optimizing the machining parameters, the micro-pillar was successfully prepared with an aspect ratio of as high as 42.25 by GFM. A 5 x 5 micro-pillar array of monocrystalline diamond was also fabricated with consistent diameter, height and aspect ratio. With Raman spectroscopy, the graphitization induced by GFM was slight, though it was unavoidably introduced with relatively high average laser power. Besides, the graphitizing level on the lateral face of the machined micro-pillar was found to non-linearly change with different machining parameters, because the material removal mode underwent a transformation from graphitization dominated to sublimation dominated with the increasing of applied energy density.

Fabrication of hundreds of microns three-dimensional single crystal diamond channel along with high aspect ratio by two-step process

Fabrication of a Micron-Scale Three-Dimensional Single Crystal Diamond Channel Using a Micro-Jet Water-Assisted Laser

Fabrication of Microchannels in Single Crystal Diamond for Microfluidic Systems

High-quality fabrication of diamond straight microchannels heat sink with large aspect ratio microchannels using UV nanosecond laser based on multi-feed method

Microfabrication Assisted by Laser-Trapped Microparticle Tools

Fabrication and electrical characterization of three-dimensional graphitic microchannels in single crystal diamond

Growth of diamond microchannels on micro-grooved graphite substrate by MPCVD

Fabrication and characterization of high quality micro diamonds by hot filament CVD

Fabrication of micro-pillar with high aspect ratio on monocrystalline diamond by galvanometer-assisted femtosecond laser milling

The fabrication of nanocrystalline diamond films using hot filament CVD

Fabrication of Diamond Microstructures by Using Dry and Wet Etching Methods

Fabrication of Single-Crystal Silicon Nanoslits with Feature Sizes Down to 4 nm and High Length-Width Ratios

Fabrication of angstrom-scale two-dimensional channels for mass transport

Large Area Single-Crystal Diamond Synthesis by 915 MHz Microwave Plasma-Assisted Chemical Vapor Deposition

Wafer-scale Fabrication of High-Aspect Ratio Nanochannels Based on Edge-Lithography Technique.

Fabrication of concave microlenses on a diamond by a spin coating process.

Fabrication of Three-Dimensional Microchannels Inside Silicon Using A Femtosecond Laser

Diamond single crystal-polycrystalline hybrid microchannel heat sink strategy for directional heat dissipation of hot spots in power devices

Fabrication of Three-Dimensional Helical Microchannels with Arbitrary Length and Uniform Diameter Inside Fused Silica

Advanced Fabrication of Single-crystal Diamond Membranes for Quantum Technologies

Diffraction Grating Microfabrication by ICP Technique with Two-Layer Lift-off Processing in Single Crystal Diamond