Abstract:A novel micro-electromechanical systems inertial switch based on non-silicon surface micromachining technology has been designed, fabricated and characterized in the present work. Compared with the traditional inertial switch, a compliant cantilever beam as a stationary electrode has been proposed to prolong the contact time, which can realize sufficient elastic deformation during the contact between the electrodes. The dynamic contact process is analyzed theoretically and the corresponding mechanical impact mechanism is also explained. To investigate the contact-enhancing mechanism of the cantilever beam, the switch applied half-sine acceleration with various amplitudes in the sensitive direction is simulated with ANSYS software. The dynamic simulation results confirm the contact-enhancing mechanism described by the theoretical analysis and it is shown that the contact time (i.e., the switch-on time) can be prolonged effectively by utilizing the elastic deformation of the cantilever beam and increased with the applied accelerations. The inertial switch is successfully fabricated by electroplating and sacrificial layer processes technologies. The prototype has been characterized by dropping hammer experiment. The test results indicate that the contact effect is improved significantly and the contact time is ∼80 µs under the 297 g acceleration, and the maximum value is ∼410 µs for the 672 g acceleration amplitude, which is in general accordance with the simulated results. The mechanical contact between the cantilever beam and the proof mass is evaluated following thousands of impacts. The scanning electron micrographs of the contact surfaces indicate that the all-metal switch still keeps a good mechanical property after suffering the hot contact, and the contact resistance is also stable.

A Planar Single-Actuator Bi-Stable Switch Based On Latch-Lock Mechanism

A Planar Single-Actuator Bi-Stable Mechanical Latch As an Electrical Switch

A Planar Single-Actuator Bi-Stable Mechanical/Electrical Switch

A Planar Single-Actuator Bi-Stable Switch Based on Hookless Mechanism

Micro-Fabricated bi-stable Mechanical Switch Actuated by a Single Thermal Actuator

High Durability Latch-Lock Bi-Stable Switch on Y-Shaped Cantilever

A single-input state-switching building block harnessing internal instabilities

A Bi-Stable Mechanism Actuated by Patterned Permanent Magnet and Cu-Ni Integrated Micro-Coil

Study on opto-thermal drive micro-switch fabricated based on LIGA technology

An Acceleration Switch with A Robust Latching Mechanism and Cylindrical Contacts

A new latched 2×2 optical switch using bi-directional movable electrothermal H-beam actuators

A Magnet‐Driven Soft Bistable Actuator

Nanoelectromechanical Switch with Low Voltage Drive

An Approach of Inertial Generated Timing Sequence for Bi-Stable MEMS Switches

An Approach to Near Zero Power Bi-Stable Driving With a Simple Pulse Signal for RF MEMS Switch

An acceleration latching switch with flexible contacts and barb latching mechanism

Fabrication of A Nanoelectromechanical Switch Using A Suspended Carbon Nanotube

A laterally-driven micromachined inertial switch with a compliant cantilever beam as the stationary electrode for prolonging contact time

Micro-cantilever Shocking-Acceleration Switches with Threshold Adjusting and ‘On’-State Latching Functions

Design, Fabrication and Characterization of A Latching Acceleration Switch with Multi-Contacts Independent to the Proof-Mass