Abstract:A horseshoe vortex (HV) system is formed around a bed-mounted circular cylinder in overland water flowing past the cylinder; however, the effect of bed roughness on HV still lacks clear recognition. The present study experimentally investigated the characteristics of HV upstream of a bed-mounted circular cylinder in a flume, where sand of four grain sizes was glued to the flume bed to produce the bed roughness. A particle image velocimetry system was mounted on the flume to facilitate a high-resolution (63 pixel/mm) observation of a flow field. A total of 28 cases with flow depths varying from 0.39 to 1.09 cm and cylinder Reynolds numbers (ReD ) varying from 2700 to 5800 were selected to evaluate the effects of the bed roughness on HV in overland flow conditions. Measurements were then conducted on the upstream flow of a cylinder in the symmetry plane. Bed roughness significantly affected HV, in turn destroying the three vortices. Subsequently, time-averaged primary HV features on the three beds with lower roughness levels were analyzed in terms of the separation point, location, radius, and swirling strength. With an increase in the bed roughness, the separation point moved toward the cylinder, and the primary HV moved toward a free surface; however, the effect on the streamwise location was nonsignificant. A positive relationship was observed between the radius of the primary HV and the bed roughness, whereas a negative relationship was observed between the swirling strength and bed roughness. For beds with the highest roughness levels, all vortices were destroyed, and there was no clear HV topology in the time average sense. Finally, the motion process of the HV was summarized as showing an increase in the bed roughness. The present study investigated HV features with different bed roughness levels and has the potential to enhance our theoretical understanding of the relationship between HV kinematic characteristics and the bed roughness.

Experimental Investigation on Hydrodynamic Behavior in a Spouted Bed with Longitudinal Vortex Generators

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Experimental Investigation on Gas-Solid Hydrodynamics of Coarse Particles in A Two-Dimensional Spouted Bed

Experimental Studies of Particle Flow Dynamics in A Two-Dimensional Spouted Bed

Investigation on the influence of vortex generator on particle resuspension

Three-Dimensional Modeling of Gas–Solid Motion in a Slot-Rectangular Spouted Bed with the Parallel Framework of the Computational Fluid Dynamics–Discrete Element Method Coupling Approach

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Hydrodynamic Behavior of a Three‐Phase Spouted Bed with Very Large Particles

Flow patterns of solids in a two-dimensional spouted bed with draft plates: PIV measurement and DEM simulations

Influences of operating parameters on the hydrodynamics of a 3-D spout–fluid bed based on DEM modeling approach

Experimental investigation about the incipient velocity of spherical particles on a hemispherical bed surface

Promotion of particle agglomeration by different vortex generator angles based on PIV-PDPA experiment

Experimental Study of Gas-Solid Fluidized Bed Hydrodynamics Using Optical Fiber Probe

Hydrodynamics of Large Jetting Fluidized Bed.

Effects of bed roughness on a horseshoe vortex in overland water flowing past a cylinder

CFD–DEM–VDGM Method for Simulation of Particle Fluidization Behavior in Multi-Ring Inclined-Hole Spouted Fluidized Bed

Gas–solid flow mechanism of spherocylindrical particles with various aspect ratios in spouted bed

Gas Discharge Patterns in a Large Jetting Fluidized Bed with a Vertical Nozzle

Modeling of dense particle flow in the annulus of spouted beds with draft tube