Abstract:Spout-fluid beds are widely used in the process industry due to their facilitation of an efficient contact between particles and gas. In this paper, a two-fluid model (TFM) is set up to reproduce the various flow structures encountered during spout-fluid bed operation. The effects of normal restitution model and gas-solid drag model are assessed by comparing simulation results with the experimental and discrete particle modeling (DPM) data of Link et al. [Link et al. Chem. Eng. Sci. 2005, 60, 3425-3442; Link et al. AIChE J. 2008, 54, 1189-1202.]. Simulation results show that application of an effective restitution coefficient in TFM can improve the accuracy of prediction significantly. The drag model of HKL predicts a more reasonable result than models of Huilin-Gidaspow, BVK, and Syamlal and O'Brien. Analysis on relative contributions of kinetic motion, friction, and collision to particle-particle momentum transfer parameters, namely, particle pressure and viscosity, shows that particle-particle momentum transfer in the spout and fountain regions is dominated by kinetic motion and that in the annulus region is dominated by friction. A transition region between spout and annulus regions is proposed. This region can be delineated using a single parameter of dimensionless collisional particle pressure because in this region, particle pressure is dominated by the collisional contribution. With an increasing spout-fluid ratio, the stable spout-annulus-fountain structure gradually shifts to an unstable bubble-slug structure. The effect of collision increases and extends to the entire bed. Meanwhile, the effects of kinetic motion and friction decrease. When slugs are formed, a rebound in the influence of friction is observed, accompanied by a decrease in the influence of collision.

Hydrodynamic Behavior of a Three‐Phase Spouted Bed with Very Large Particles

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Experimental Investigation on Gas-Solid Hydrodynamics of Coarse Particles in A Two-Dimensional Spouted Bed

CFD Simulation of Hydrodynamic Characteristics in a Multiple-Spouted Bed

Influences of operating parameters on the hydrodynamics of a 3-D spout–fluid bed based on DEM modeling approach

Hydrodynamic Characteristics of a Novel Annular Spouted Bed with Multiple Air Nozzles

Experimental Research on the Gas-Solid Flow Characteristics in Large-Scale Dual Fluidized Bed Reactor

Three-Dimensional Modeling of Gas–Solid Motion in a Slot-Rectangular Spouted Bed with the Parallel Framework of the Computational Fluid Dynamics–Discrete Element Method Coupling Approach

Two-Fluid Simulation of a Three-Dimensional Spout-Fluid Bed: Flow Structures, Regimes, and Insight into the Mechanism of Particle–Particle Momentum Transfer

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Effect of Operating Parameters on Gas‐Solid Hydrodynamics and Heat Transfer in a Spouted Bed

Hydrodynamic Characteristics of a Powder‐Particle Spouted Bed with Powder Entrained in Spouting Gas

Numerical and Experimental Study of Integral Multi-Jet Structure Impact on Gas-Solid Flow in a 3D Spout-Fluidized Bed

Study on the Hydrodynamics of a Spouting−Moving Bed

Hydrodynamics of Sawdust in a Spout-Fluid Bed with Draft Tube

Experimental Study on Particles Spouting Characteristics in a Novel Annular Spouted Bed

Hydrodynamics of a Spouted Bed with Draft Tube

Hydrodynamics of Three-Phase Internal-Loop Airlift Reactor with Large Particles

Spoutable Bed Height and Pressure Fluctuation of a Novel Annular Spouted Bed with V-shaped Deflector