Abstract:This study presents an adaptive algorithm for distance relays. In this algorithm, the network connected to the transmission line terminals are modelled using an equivalent circuit, and the impedances of this equivalent circuit are estimated. By employing this algorithm, relay errors (over/under reach) caused by changes in network structure, the presence of fault resistance, and injected current from the remote end of the transmission line are eliminated. As a result, the relay accurately determines fault location and fault resistance, enhancing the performance of its Zone1 and Zone2 functions. Faults in power systems occur for various reasons, such as aging or natural disasters. Detecting, locating, and promptly clearing these faults is crucial for maintaining the safety and reliability of transmission lines (TLs). Distance relays (DRs), which protect TLs, detect faults, estimate their location, and send the required commands. However, these relays may experience mis‐detection due to manipulated impedance arising from both internal and external factors. These factors include measurement device errors, network topology changes, the presence of fault resistance (FR), and injected currents from remote line terminals. To address this challenge, an innovative adaptive protection scheme that considers FR, changes in network topology, and injected current from the opposite end of the line is proposed. By estimating the equivalent circuit impedances (ECIs) of the network connected to the terminal of the TL, this protection scheme utilizes impedance estimation techniques at the line terminals and offline network information. Simulation studies (tested on the IEEE 39‐bus standard network) show that the proposed scheme accurately estimates fault location (FL) and FR with high precision. The simulation results demonstrate its effectiveness in improving the performance of conventional distance protection relays in both the first and second protection zones (Zone1 and Zone2 ).

Multiphase Compensated Distance Relay Insensitive to Transition Resistances

Distance Protection That Insensitive to Power Swing

Performance analysis of multiphase compensated distance relay in single-phase-to-ground fault with power swing

New Type Adaptive Distance Relay with Improved Performance

Distance Protection Principle for Series Compensated Lines Based on the Impedance Angle of the Compensated Point

Adaptive Distance Relay for Preventing Error Action of Reactive Fault

A Distance Protection Scheme of Series Compensated Lines Based on Model Identification in Frequency Domain

An Adaptive Distance Relay Based On Transient Error Estimation Of Cvt

Error Analysis of Distance Relay Protection in Phase-to-Phase Short Circuit Fault

An Improved Fault Phase Selector for Transmission Line Protective Relay

An adaptive distance protection scheme considering fault resistance, injected current, and structural changes in the power system

Performance analysis of phase distance relay on series compensated UHV lines

The uniform formula of single phase earth - fault distance relay with compensation

A Novel Method of Power Swing Blocking in Impedance Relay

A single-phase ground distance protection scheme based on compensated cosine volume

Traveling-wave Differential Relay Scheme for Double-circuit Parallel Lines on the Same Pole

Adaptive distance protection based on R-L model error

A Novel Distance Protection Algorithm for the Phase-Ground Fault

Active Phase Control to Enhance Distance Relay in Converter-Interfaced Renewable Energy Systems