Experimental Study on the Phase Control Closing of Vacuum Circuit Breakers for No-load Transformer

Haoqing WANG,Haifang YANG,Jinyang LIN,Ning LIU,Xiangyang LI,Yuchun LI,Guowei KONG,Yingsan GENG,Zhiyuan LIU

DOI: https://doi.org/10.13296/j.1001-1609.hva.2017.03.027

2017-01-01

Abstract:Power transformer is a crucial component in power system,and it is the most expensive equipment in substation.The nonlinear characteristics of transformer would result in significant magnetizing inrush current when closing a no-load transformer,and the current amplitude would reach up to dozens of times of the steady state current.In general,the decay rate of magnetizing inrush current is slower than that of short circuit current.Thus the high magnitude magnetizing inrush current would cause the maloperation of protection equipment in the transformer,the increase in mechanical stress of the windings,and the deterioration of the power quality.Fortunately,phase control closing of vacuum circuit breaker is a satisfactory solution to this problem.In this study,a test of closing no-load transformer by a 12 kV vacuum circuit breaker was conducted in the 6 kV direct test circuit of CEPRI.The magnetizing inrush current during random closing,common phase control closing,and phase control closing with calculating remanence was measured in order to verify the effect of phase control closing.The results indicate that the phase control closing,especially the phase control closing with calculating remanence,is effective in reducing the magnetizing inrush current compared with random closing.However,the prestrike characteristic of a vacuum circuit breaker influences the effect of phase control closing even though the phase control closing with calculating remanence is employed.