Abstract:A large number of silicone rubber (SR) insulators have been used in inland areas. Long-term performance evaluation, pre-ranking and selection of these insulators are highly significant. IEC and other institutes have proposed several 5000 h tests with multiple stresses to evaluate long-term performances of composite insulators. However, these procedures have their own characteristics and limitations. None of the existing tests could provide a satisfactory simulation of the condition with severe contamination and high non-soluble deposit density (NSDD) in inland areas as well as the hydrophobicity change process of SR insulators. Based on modifications of the IEC test procedure, a novel 5000 h test procedure is proposed. There are two main modifications. The first one aims to replace the salt fog with a mixed contamination fog including both soluble and non-soluble pollutants. The second one aims to provide sufficient time for SR to recover and to transfer its hydrophobicity. A set of test apparatus based on this novel 5000h test procedure was designed and constructed. Two tests were conducted on 16 SR insulators with different material compositions and shed designs, including an AC and a negative DC test. Contamination accumulation on the surfaces of the specimens during both tests were measured. The NSDD and equivalent salt deposit density (ESDD) were close to those measured in the field in contaminated inland areas. Hydrophobicity reduction and recovery were well reproduced. Discharge activities were observed and leakage current was measured, which were consistent with the hydrophobicity statuses of the specimen. Tracking and erosion were found for some specimens, and the damage pattern was the same with that found in the field. The poor material properties and inappropriate shed designs could be identified successfully through the test. It was concluded that the modified 5000 h procedure could provide a satisfactory simulation of the desired contamination condition and hydrophobicity change process, and the insulators with different design defects are successfully screened out.

Tracking Wheel Test for Composite Insulator with Large Diameter: Part Ⅱ-Circumferential Distribution of Leakage Current

Investigation on Tracking Wheel Test of Large-Diameter Composite Insulators under AC Voltage

Study of Tracking Wheel Test Method under DC Voltage

Circle Tests of Tracking and Erosion of the Composite Insulator

ANALYSIS ON FAILURES OF SILICON RUBBER COMPOSITE INSULATORS IN TRACKING WHEEL TEST

Leakage Current Analysis and Arc Identification in AC Incline Plane Test

Influence of Partial Electric Arc on the Contamination Degree Monitoring System in View of Leakage Current

Study On Interface Between Core And Sheath Of Composite Insulator Based On Leakage Current

A Modified 5000 H Test Procedure for Silicone Rubber Insulator Based on Contamination and Hydrophobicity Change Simulation

Effect of Ageing on the Tracking Characteristics of High-Temperature Vulcanized Silicone Rubber Hybrid Composites for High Voltage Insulation

Investigation of Surface Degradation of Aged High Temperature Vulcanized (HTV) Silicone Rubber Insulators

Leakage Current and Discharge Phenomenon of Outdoor Insulators

Numerical Investigations of Leakage Performance Degradations in Labyrinth and Flexible Seals Due to Wear

Time and Frequency Analysis on Leakage Current Waveforms of Discharges along Hydrophobic and Hydrophilic Surfaces

Analysis of the leakage current pulses of outdoor insulators in different relative humidity

Micro characterization of aged liquid silicone rubber used for 220kV current transformer jacket

Aging Characteristics Analysis of Inter-turn Insulation Using Dielectric Loss

Aging diagnosis of large generator stator winding insulation based on ac dielectric characteristic parameters

Hydrophobicity Distribution Analysis of DC Composite Insulators

Leakage current pattern for diagnosing the contaminated degree of ceramic insulators under different humidity

Artificial Aging Tests with Defective Composite Insulators