Abstract:To tackle the challenge of localization failure due to traveling wave dispersion during a mid-line fault in a long high-voltage cable, this study conducts an in-depth analysis of the refraction characteristics of the cumulative three-phase sheath currents at cross commutation points and direct grounding points, facilitated by detailed theoretical derivation. We introduce the novel concept of a 'first traveling wave attenuation index,' which quantifies the peak of the initial faulted traveling wave. We strategically place distributed traveling wave detection devices solely in the first direct grounding box of each cross-interconnected main section, effectively segmenting the line into five distinct zones. These zones are identified based on the unique transient polarities exhibited by the first traveling wave of fault current at each impedance mismatch point along the cable. To overcome the issue of weak traveling wave signals collected at the first end measurement point, we propose an innovative peak detection method for the first wave. This method harnesses the power of empirical wavelet transform (EWT) and multi-resolution singular value decomposition (MRSVD), providing a significant boost in ranging accuracy compared to traditional wavelet methods. Simulation results validate the efficacy of our proposed fault location method, which accurately pinpoints the fault section by contrasting the polarity of the first wave peak of the sheath current detected at each measurement point. Notably, our method ensures safety and convenience as the equipment does not require direct contact with high voltage.

Positioning Method for Fault Section Based on Wide Area Measurement

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Fault Location Method Based on Full Waveform Information for Distribution Networks

A Fault Section Location Method for Small Current Neutral Grounding System Based on Energy Relative Entropy of Generalized S-Transform

Fault Location Method in Resonant Grounded Networks Based on Distributed Modulation and Compensation Adjustment

Fault Location Method for Distribution Networks Based on Leakage Energy Function

Phase Current Based Fault Section Location for Single-Phase Grounding Fault in Non-effectively Grounded Distribution Network

Fault location based on variable mode decomposition and kurtosis calibration in distribution networks

Faulty Section Location Method Based on Dynamic Time Warping Distance in a Resonant Grounding System

A Distributed Fault Location Algorithm for Single-Phase Ground Fault by Comprehensive Analysis on Fault Current Information

A Novel Fault Location Method for High Impedance Grounding Fault in Distribution Network

A Novel Current Travelling Wave Based Single-Ended Fault Location Method for Locating Single-Phase-to-ground Fault of Transmission Line

Distributed Fault Location Based on Comprehensive Analysis of Fault Current

Design of fault location algorithm based on online distributed travelling wave for HV power cable

Grounding fault test technology of distribution network based on zero sequence power direction judgment

A Method of Single Phase to Ground Fault Feeder Selection Based on Single Phase Current Traveling Wave for Distribution Lines

A non-contact current traveling wave fault location method for multi-terminal overhead power lines based on adaptive mathematical morphology

Study onFault Location Method Based on Leakage Energy Function

New Method for Fault Positioning Based on Nodal Impedance Matrix and Voltage Sag

A Novel Single-Ended Traveling Wave Fault Location Method Based on Reflected Wave-Head of Adjacent Bus

Fault location method based on edge detection for low SNR traveling waves