Abstract:Aluminum nitride (AlN)-on-Si MEMS resonators operating in Lamb wave modes have found wide applications for physical sensing and frequency generation. Due to the inherent layered structure, the strain distributions of Lamb wave modes become distorted in certain cases, which could benefit its potential application for surface physical sensing. This paper investigates the strain distributions of fundamental and first-order Lamb wave modes (i.e. S0, A0, S1, A1 modes) associated with their piezoelectric transductions in a group of AlN-on-Si resonators. The devices were designed with notable change in normalized wavenumber resulting in resonant frequencies ranging from 50 to 500 MHz. It is shown that the strain distributions of four Lamb wave modes vary quite differently as normalized wavenumber changes. In particular, it is found that the strain energy of A1-mode resonator tends to concentrate to the top surface of acoustic cavity as the normalized wavenumber increases, while that of S0-mode device becomes more confined in the central area. By electrically characterizing the designed devices in four Lamb wave modes, the effects of vibration mode distortion on resonant frequency and piezoelectric transduction were analyzed and compared. It is shown that designing A1-mode AlN-on-Si resonator with identical acoustic wavelength and device thickness benefits its surface strain concentration as well as piezoelectric transduction, which are both demanded for surface physical sensing. We herein demonstrate a 500-MHz A1-mode AlN-on-Si resonator with decent unloaded quality factor (Qu = 1500) and low motional resistance (Rm = 33 Ω) at atmospheric pressure.

Ultralow Acoustic Loss Micromachined Butterfly Lamb Wave Resonators on AlN Plates

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

AlN/Al0.8Sc0.2N film S0 mode lamb wave resonator with spurious mode suppression

Ultra flexible pseudo-lamb wave RF resonators based on ZnO/PI and AlN/PI structures

High Electromechanical Coupling Factor Lamb Wave Resonator

Transducer design for AlN Lamb wave resonators

Spurious-Free S1 Mode AlN/ScAlN-Based Lamb Wave Resonator With Trapezoidal Electrodes

High Figure-of-Merit A1-Mode Lamb Wave Resonators Operating Around 6 GHz Based on the LiNbO3 Thin Film

Analysis and Suppression of Spurious In-Plane Lamé-Like Modes in Lamb Wave Resonators

422 Million intrinsic quality factor planar integrated all-waveguide resonator with sub-MHz linewidth

Surface acoustic wave resonators based on (002)AlN/Pt/diamond/silicon layered structure

A Novel Lamé Mode RF-MEMS resonator with high quality factor

Fano Resonances in Ultracompact Waveguide Fabry-Perot Resonator Side-Coupled Lossy Nanobeam Cavities

Matryoshka Phononic Crystals for Anchor-Loss Reduction of Lamb Wave Resonators

Fusion Spliced Microfiber Closed-Loop Resonators

High Q‐factor Anapole Mode Based on Localized Spoof Surface Plasmon Polaritons

Low-Loss Higher-Order Cross-Sectional Lamé Mode SAW Devices in 10-20 GHz Range

Investigation on Quasi Lamb Wave Modes in AlN-on-Si MEMS Resonators

Ultrahigh-Q lithium niobate microring resonator with multimode waveguide.

High-Performance SAW Resonators Based on Single-crystalline a-Plane AlN Thin Films on Sapphire Substrates

Dominant Loss Mechanisms of Whispering Gallery Mode RF-MEMS Resonators with Wide Frequency Coverage