Abstract:The surge in air pollution and respiratory diseases across the globe has spurred significant interest in the development of flexible gas sensors prepared by low-cost and scalable fabrication methods. However, the limited breathability in the commonly used substrate materials reduces the exchange of air and moisture to result in irritation and a low level of comfort. This study presents the design and demonstration of a breathable, flexible, and highly sensitive NO2 gas sensor based on the silver (Ag)-decorated laser-induced graphene (LIG) foam. The scalable laser direct writing transforms the self-assembled block copolymer and resin mixture with different mass ratios into highly porous LIG with varying pore sizes. Decoration of Ag nanoparticles on the porous LIG further increases the specific surface area and conductivity to result in a highly sensitive and selective composite to detect nitrogen oxides. The as-fabricated Ag/LIG gas sensor on a flexible polyethylene substrate exhibits a large response of −12‰, a fast response/recovery of 40/291 s, and a low detection limit of a few parts per billion at room temperature. Integrating the Ag/LIG composite on diverse fabric substrates further results in breathable gas sensors and intelligent clothing, which allows permeation of air and moisture to provide long-term practical use with an improved level of comfort.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.2c02061.Design and geometric parameters of the gas sensor; optical images of the F127/resols and corresponding LIG patterns (insets) on varying substrates; deconvoluted C 1s of the LIG prepared by the 3:2 F127/resols; SEM image of Ag-coated LIG (3:2 mass ratio) and the corresponding EDS spectrum; optical image of the four-point probe and the resulting sheet resistance measurements; current–voltage (I–V) curves of the LIG with three different F127/resol mass ratios; typical response curve of the pristine LIG gas sensor with the largest pore size to 1 ppm NO2; schematic diagram showing the sensing mechanism of the Ag/LIG composite to NO2; analysis of the peak intensity ratios of the D and 2D to G obtained from the Raman spectra; XPS analysis of the Ag 3d intensity in the Ag/LIG composite; optical images of the Ag/LIG composite on knitted fabric, Kevlar fiber, and non-woven fabric to demonstrate the large-scale production; dynamic response curves of a Ag/LIG-based gas sensor on three different fabric substrates upon exposure to NO2 ranging from 0.5 to 2.5 ppm; and comparison in the weight change between the bottles covered by the knitted fabric and that with three different Ag/LIG composites (PDF)This article has not yet been cited by other publications.

Mosaic-Like Micropatterned Monolayer RGO/AgNPs Film Gas Sensor with Enhanced Room-Temperature NO2 Response/Recovery Properties

Bioinspired supramolecular arrayed heterojunction-based room-temperature sensor for high-performance gas detection

MOSAIC-LIKE MONOLAYER RGO/AG FILM VIA ULTRAFAST TWO-DIMENSIONAL ASSEMBLY FOR HIGH PERFORMANCE ROOM-TEMPERATURE GAS SENSOR

Ag-Modified 3D Reduced Graphene Oxide Aerogel-Based Sensor with an Embedded Microheater for a Fast Response and High-Sensitive Detection of NO2.

High Performance Acoustic Wave Nitrogen Dioxide Sensor with Ultraviolet Activated 3D Porous Architecture of Ag-Decorated Reduced Graphene Oxide and Polypyrrole Aerogel

A Room-Temperature NO2 Gas Sensor Based on CuO Nanoflakes Modified with Rgo Nanosheets

Sprayed, Scalable, Wearable, and Portable NO2 Sensor Array Using Fully Flexible AgNPs-All-Carbon Nanostructures.

Interface engineering of a highly sensitive porous CuO modified rGO layers for room temperature NO 2 gas sensor

Highly sensitive and rapidly responding room-temperature NO 2 gas sensors based on WO 3 nanorods/sulfonated graphene nanocomposites

Confined Formation of Ultrathin ZnO Nanorods/Reduced Graphene Oxide Mesoporous Nanocomposites for High-Performance Room-Temperature NO 2 Sensors.

Flexible Nitrogen Dioxide Gas Sensor Based on Reduced Graphene Oxide Sensing Material Using Silver Nanowire Electrode

A High Response Three-Dimensional Ag Nanoparticles/Rgo Microtubular Field Effect Transistor Sensor For No2 Detections

A High Response Three-Dimensional Ag Nanoparticles/Rgo Microtubular Field Effect Transistor Sensor for No<inf>2</inf> Detections

Highly Sensitive, Selective, Flexible and Scalable Room-Temperature NO<sub>2</sub> Gas Sensor Based on Hollow SnO<sub>2</sub>/ZnO Nanofibers

SnO2 Nanoparticles Incorporated CuO Nanopetals on Graphene for High-Performance Room-Temperature NO2 Sensor

Zno Nanoarrays Via A Thermal Decomposition-Deposition Method For Sensitive And Selective No2 Detection

Boosting Room-Temperature Ppb-Level NO2 Sensing over Reduced Graphene Oxide by Co-Decoration of Α-Fe2o3 and SnO2 Nanocrystals.

Intrinsically Breathable and Flexible NO 2 Gas Sensors Produced by Laser Direct Writing of Self-Assembled Block Copolymers

Light-assisted Recovery for a Highly-Sensitive NO2 Sensor Based on RGO-CeO2 Hybrids

Three-Dimensional MoS2/Reduced Graphene Oxide Nanosheets/Graphene Quantum Dots Hybrids for High-Performance Room-Temperature NO2 Gas Sensors

Three-Dimensional Fe3O4@Reduced Graphene Oxide Heterojunctions for High-Performance Room-Temperature NO2 Sensors