Intrinsically Breathable and Flexible NO 2 Gas Sensors Produced by Laser Direct Writing of Self-Assembled Block Copolymers

Li Yang,Huadong Ji,Chuizhou Meng,Yuhang Li,Guanghao Zheng,Xue Chen,Guangyu Niu,Jiayi Yan,Ye Xue,Shijie Guo,Huanyu Cheng
DOI: https://doi.org/10.1021/acsami.2c02061
2022-04-08
Abstract:The surge in air pollution and respiratory diseases across the globe has spurred significant interest in the development of flexible gas sensors prepared by low-cost and scalable fabrication methods. However, the limited breathability in the commonly used substrate materials reduces the exchange of air and moisture to result in irritation and a low level of comfort. This study presents the design and demonstration of a breathable, flexible, and highly sensitive NO2 gas sensor based on the silver (Ag)-decorated laser-induced graphene (LIG) foam. The scalable laser direct writing transforms the self-assembled block copolymer and resin mixture with different mass ratios into highly porous LIG with varying pore sizes. Decoration of Ag nanoparticles on the porous LIG further increases the specific surface area and conductivity to result in a highly sensitive and selective composite to detect nitrogen oxides. The as-fabricated Ag/LIG gas sensor on a flexible polyethylene substrate exhibits a large response of −12‰, a fast response/recovery of 40/291 s, and a low detection limit of a few parts per billion at room temperature. Integrating the Ag/LIG composite on diverse fabric substrates further results in breathable gas sensors and intelligent clothing, which allows permeation of air and moisture to provide long-term practical use with an improved level of comfort.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.2c02061.Design and geometric parameters of the gas sensor; optical images of the F127/resols and corresponding LIG patterns (insets) on varying substrates; deconvoluted C 1s of the LIG prepared by the 3:2 F127/resols; SEM image of Ag-coated LIG (3:2 mass ratio) and the corresponding EDS spectrum; optical image of the four-point probe and the resulting sheet resistance measurements; current–voltage (I–V) curves of the LIG with three different F127/resol mass ratios; typical response curve of the pristine LIG gas sensor with the largest pore size to 1 ppm NO2; schematic diagram showing the sensing mechanism of the Ag/LIG composite to NO2; analysis of the peak intensity ratios of the D and 2D to G obtained from the Raman spectra; XPS analysis of the Ag 3d intensity in the Ag/LIG composite; optical images of the Ag/LIG composite on knitted fabric, Kevlar fiber, and non-woven fabric to demonstrate the large-scale production; dynamic response curves of a Ag/LIG-based gas sensor on three different fabric substrates upon exposure to NO2 ranging from 0.5 to 2.5 ppm; and comparison in the weight change between the bottles covered by the knitted fabric and that with three different Ag/LIG composites (PDF)This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology
What problem does this paper attempt to address?