Abstract:The surge in air pollution and respiratory diseases across the globe has spurred significant interest in the development of flexible gas sensors prepared by low-cost and scalable fabrication methods. However, the limited breathability in the commonly used substrate materials reduces the exchange of air and moisture to result in irritation and a low level of comfort. This study presents the design and demonstration of a breathable, flexible, and highly sensitive NO2 gas sensor based on the silver (Ag)-decorated laser-induced graphene (LIG) foam. The scalable laser direct writing transforms the self-assembled block copolymer and resin mixture with different mass ratios into highly porous LIG with varying pore sizes. Decoration of Ag nanoparticles on the porous LIG further increases the specific surface area and conductivity to result in a highly sensitive and selective composite to detect nitrogen oxides. The as-fabricated Ag/LIG gas sensor on a flexible polyethylene substrate exhibits a large response of −12‰, a fast response/recovery of 40/291 s, and a low detection limit of a few parts per billion at room temperature. Integrating the Ag/LIG composite on diverse fabric substrates further results in breathable gas sensors and intelligent clothing, which allows permeation of air and moisture to provide long-term practical use with an improved level of comfort.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.2c02061.Design and geometric parameters of the gas sensor; optical images of the F127/resols and corresponding LIG patterns (insets) on varying substrates; deconvoluted C 1s of the LIG prepared by the 3:2 F127/resols; SEM image of Ag-coated LIG (3:2 mass ratio) and the corresponding EDS spectrum; optical image of the four-point probe and the resulting sheet resistance measurements; current–voltage (I–V) curves of the LIG with three different F127/resol mass ratios; typical response curve of the pristine LIG gas sensor with the largest pore size to 1 ppm NO2; schematic diagram showing the sensing mechanism of the Ag/LIG composite to NO2; analysis of the peak intensity ratios of the D and 2D to G obtained from the Raman spectra; XPS analysis of the Ag 3d intensity in the Ag/LIG composite; optical images of the Ag/LIG composite on knitted fabric, Kevlar fiber, and non-woven fabric to demonstrate the large-scale production; dynamic response curves of a Ag/LIG-based gas sensor on three different fabric substrates upon exposure to NO2 ranging from 0.5 to 2.5 ppm; and comparison in the weight change between the bottles covered by the knitted fabric and that with three different Ag/LIG composites (PDF)This article has not yet been cited by other publications.

Stretchable, ultrasensitive, and low-temperature NO2 sensors based on MoS2@rGO nanocomposites

Three-Dimensional MoS2/Reduced Graphene Oxide Nanosheets/Graphene Quantum Dots Hybrids for High-Performance Room-Temperature NO2 Gas Sensors

Moisture-resistant, stretchable NOx gas sensors based on laser-induced graphene for environmental monitoring and breath analysis

Ultrasensitive flexible NO2 gas sensors via multilayer porous polymer film

Hollow Cu2O nanospheres loaded with MoS2/reduced graphene oxide nanosheets for ppb-level NO2 detection at room temperature

Design of Hetero-Nanostructures on MoS2 Nanosheets To Boost NO2 Room-Temperature Sensing

In situ laser-assisted synthesis and patterning of graphene foam composites as a flexible gas sensing platform

Flexible Nitrogen Dioxide Gas Sensor Based on Reduced Graphene Oxide Sensing Material Using Silver Nanowire Electrode

Controllable Epitaxial-like Growth of Bi 2 S 3 /MoS 2 Hybrid Aerogel Nanostructures for Sensitive NO 2 Detection at Room Temperature

Highly sensitive and recoverable room-temperature NO<sub>2</sub> gas detection realized by 2D/0D MoS<sub>2</sub>/ZnS heterostructures with synergistic effects

Facile Fabrication of MoS 2 Nanoflowers/SnO 2 Colloidal Quantum Dots Nanocomposite for Enhanced NO 2 Sensing at Room Temperature

CTAB Enhanced Room-Temperature Detection of NO2 Based on MoS2-Reduced Graphene Oxide Nanohybrid

Synergistic CNFs/CoS2/MoS2 Flexible Films with Unprecedented Selectivity for NO Gas at Room Temperature

Ultrasensitive NO 2 Gas Sensors Based on Layered α‐MoO 3 Nanoribbons

Intrinsically Breathable and Flexible NO 2 Gas Sensors Produced by Laser Direct Writing of Self-Assembled Block Copolymers

Flexible Resistive Gas Sensor Based on Molybdenum Disulfide-Modified Polypyrrole for Trace NO2 Detection

Highly enhanced response of MoS2/porous silicon nanowire heterojunctions to NO2 at room temperature

Assembly of 2D-Mos2 with Graphene Layer for Highly Sensitive and Selective Gas Detection at Room Temperature

Three-Dimensional Fe3O4@Reduced Graphene Oxide Heterojunctions for High-Performance Room-Temperature NO2 Sensors

Large-sized α-MoO3 layered single crystals for superior NO2 gas sensing

In-situ sulfidation-derived three-dimensional cobalt sulfide nanoflower/graphene nanosheet hybrid for ultrasensitive room-temperature NO2 gas sensor