Abstract:The paper presents the results of investigation of the dislocation structure, the magnitude of the curvature–torsion of the crystal lattice, the amplitudes of the internal stress fields, as well as the redistribution of carbon atoms in zones of stable localization of deformations depending on the state of samples made of structural steel 20. Samples were studied without operation, after operation without destruction, and with destruction. The samples were stretched at the same speed until a stable deformation localization zone appeared, after which the loading was stopped. To study the dislocation structure, we used the method of transmission electron microscopy on thin foils. It has been shown that deformation of samples made of structural steel 20 in the direction "initial" → "not destroyed" → "destroyed" sample in all morphological components of the structure, as well as in the material as a whole, gradually leads to a fragmentation of the structure down to a nanocrystalline structure in individual areas of the material. Dislocations move to fragment boundaries, and the scalar dislocation density ρ decreases. At the same time, internal shear stresses σ s decrease. The change in local stresses σ l is of a different nature, namely, the plastic component of local stresses decreases, and the elastic component increases sharply. It has been established that deformation of steel 20 leads to the destruction of cementite particles located at the boundaries of dislocation fragments (the volume fraction decreases) and the formation of carbides inside the fragments (their volume fraction increases). Carbon from destroyed cementite particles at the boundaries of fragments is spent on the formation of cementite particles inside the fragments, of crystal lattice defects, and the formation of carbides in new morphological structures (micro- and nanograins).

Influence of Deformation on the Structural–Phase State of Structural Steel and on the Formation of Its Yield Strength and Degree of Hardening

Effect of High Temperature Exposure and Strain Rate on Mechanical Properties of High-Strength Steel Rebars

Changes in the Stress–Strain States of Subsurface Layers of Steel During Loading

Study of Dislocation Structure, Internal Stresses, and Redistribution of Carbon Atoms in the Zone of Localized Deformation in Structural Steel 20

Effect of Strain Aging on Stages of Plastic Strain and Tensile Fracture of Specimens of Steel 08G2B. Part I. Yield Plateau and the Stage of Strain Hardening

Influence of Strain Hardening on the Behavior and Design of Steel Structures

Deformation Stages of Austenitic Cast SteeL 60Cr24NMn16 Under Different Boundary Loading Conditions

Effects of Mechanical Deformation on Dislocation Density and Phase Partitioning in 4130 Steel

A study of the deformation properties of 10GN2MFA and 15Kh2MFA steels taking into account material damageability under plane stress conditions

The Influence of Hot Deformation on the Mechanical and Structural Properties of 42CrMo4 Steel

Influence of deformation on the structure and the mechanical properties of a high-entropy Fe25Cr20Ni20Co10Mn15Al10 alloy

Influence of Different Deformation on Microstructure and Properties of 304 Austenitic Stainless Steel

Experimental Determination of a Strain State in a Bulk Forming of a Low Carbon Steel

Increase in Low-Carbon Steel 12GBA Strength and Cold Resistance by a Deformation-Thermal Effect

Analysis of hardening mechanisms of rail steel under plastic deformation by uniaxial compression

Influence of deformation degree on grains size and borders between them in metal alloys during cold rolling of sheets

Effect of Pre-strain and Strain Rate on Deformation and Fracture Behavior of Automotive Grade Interstitial Free Steel Sheets

Correlation of Tensile Deformation-Induced Strain in HSLA Steel with Residual Stress Distribution

Effect of Strain-Hardening on the Length of Plastic Zone of Steel Frames

INVESTIGATION OF THE INFLUENCE OF DEFORMATION AND HEAT TREATMENT OF STEEL ON THE PHASE COMPOSITION OF STEEL

Analysis and Modeling of Stress-Strain Curves in Microalloyed Steels Based on a Dislocation Density Evolution Model