Abstract:The paper presents the results of investigation of the dislocation structure, the magnitude of the curvature–torsion of the crystal lattice, the amplitudes of the internal stress fields, as well as the redistribution of carbon atoms in zones of stable localization of deformations depending on the state of samples made of structural steel 20. Samples were studied without operation, after operation without destruction, and with destruction. The samples were stretched at the same speed until a stable deformation localization zone appeared, after which the loading was stopped. To study the dislocation structure, we used the method of transmission electron microscopy on thin foils. It has been shown that deformation of samples made of structural steel 20 in the direction "initial" → "not destroyed" → "destroyed" sample in all morphological components of the structure, as well as in the material as a whole, gradually leads to a fragmentation of the structure down to a nanocrystalline structure in individual areas of the material. Dislocations move to fragment boundaries, and the scalar dislocation density ρ decreases. At the same time, internal shear stresses σ s decrease. The change in local stresses σ l is of a different nature, namely, the plastic component of local stresses decreases, and the elastic component increases sharply. It has been established that deformation of steel 20 leads to the destruction of cementite particles located at the boundaries of dislocation fragments (the volume fraction decreases) and the formation of carbides inside the fragments (their volume fraction increases). Carbon from destroyed cementite particles at the boundaries of fragments is spent on the formation of cementite particles inside the fragments, of crystal lattice defects, and the formation of carbides in new morphological structures (micro- and nanograins).

Changes in the Stress–Strain States of Subsurface Layers of Steel During Loading

Multi-scale Deformation Behavior Investigation of 18cr–8ni Austenitic Steel Subjected to Low-Cycle Fatigue Loading

Effect of Strain Aging on Stages of Plastic Strain and Tensile Fracture of Specimens of Steel 08G2B. Part I. Yield Plateau and the Stage of Strain Hardening

Deformation Stages of Austenitic Cast SteeL 60Cr24NMn16 Under Different Boundary Loading Conditions

Influence of Deformation on the Structural–Phase State of Structural Steel and on the Formation of Its Yield Strength and Degree of Hardening

Evolution of stress-strain state in structured rock specimens under uniaxial loading

Experimental Determination of a Strain State in a Bulk Forming of a Low Carbon Steel

Study of Dislocation Structure, Internal Stresses, and Redistribution of Carbon Atoms in the Zone of Localized Deformation in Structural Steel 20

Strain-Hardening Behavior of Dual-Phase Steel under Multistress States

Post-limit stress-strain states of steel structure elements in cross-sections

An experimental investigation of large-strain tensile behavior of a metal sheet

Influence of Strain Hardening on the Behavior and Design of Steel Structures

Extended Stress–Strain Characterization of Automotive Steels at Dynamic Rates

A Tensile Characterization Study of Metal Sheet in Large-Strain

Stress evolution in plastically deformed austenitic and ferritic steels determined using angle- and energy-dispersive diffraction

Analysis of hardening mechanisms of rail steel under plastic deformation by uniaxial compression

Analysis and Modeling of Stress-Strain Curves in Microalloyed Steels Based on a Dislocation Density Evolution Model

Optical Strain Measurement and Microfractography of the Fractures of Armstal 550 Steel after Temperature Tensile Tests

Damage accumulation in carbon steel under low-cycle loading at the crack initiation stage and strain ageing temperature

Mesomechanical Aspects of the Strain-Rate Sensitivity of Armco-Iron Pulled in Tension

Correlation of Tensile Deformation-Induced Strain in HSLA Steel with Residual Stress Distribution