Abstract:Concrete-filled high-strength steel tubes (CFHST) could improve structural efficiency with lighter weight and higher capacity. However, the relative lower ductility and higher yield-to-tensile strength ratio of high-strength steel arouse worries about seismic performance of CFHST. In order to reveal the influence of high-strength steel on the elastoplastic hysteretic behavior of CFHST, 8 cantilever columns with Q550 and Q690 steel were subjected to constant axial load and cyclic top displacement. The actual yield strength of the steel was over 700MPa and the maximum axial load ratio was over 0.5. Based on the experimental observations, a finite element model was developed in ABAQUS that could consider deep plasticity behavior of CFHST members more precisely by introducing full-range elastoplastic constitutive model of high-strength steel and damaging–crushing behavior of infill concrete. The model was validated by the 8 tests of this study and other 34 cyclic-loaded CFST specimen from different researchers. 288 cyclic-loaded CFHST models were simulated by the effective numerical model in the parametric study on the elastoplastic deformation capacity of CFHST columns. The experimental and numerical investigations show that the CFHST could still have considerable deformation capacity if the local deformation of the steel tubes develop moderately. For heavy loaded CFST columns, high-strength thin-walled steel tubes have satisfying elastoplastic deformation capacity and ductility that are not worse than CFST with thick conventional steel tubes. The application of high-strength steel could delay the steel yield and control the damage of the concrete, leading to larger pre-peak deformation capacity. Finally, the empirical formulas were proposed to roughly yet efficiently estimate the ultimate drift θu of cyclic-loaded CFSTs with fy=345∼ 690 MPa, fc’=24∼72 MPa, ξ=1.0∼6.0 and n=0.20∼0.80, which is fairly practical in plastic inter-story-drift check and seismic design of CFHST structures.

Effect of Strain-Hardening on the Length of Plastic Zone of Steel Frames

Effect of High Temperature Exposure and Strain Rate on Mechanical Properties of High-Strength Steel Rebars

Strain Ratio Effects on Low-Cycle Fatigue Behavior and Deformation Microstructure of 2124-T851 Aluminum Alloy

Research advance of influence of yield-to-tensile strength ratio on seismic behavior of steel frames

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

The effect of the yield to tensile strength ratio on stress/strain concentrations around holes in high-strength steels

Influence of Strain Hardening on the Behavior and Design of Steel Structures

Testing and Modeling the Effect of Strain-Rate on Plastic Anisotropy for A Traditional High Strength Steel

Research advances on mechanical properties of high strength structural steels

Experimental testing and plastic strain analysis of high strength steel longitudinal plate to tubular X joints

Effect of Strain Aging on Stages of Plastic Strain and Tensile Fracture of Specimens of Steel 08G2B. Part I. Yield Plateau and the Stage of Strain Hardening

Quantitative Description of Temperature- and Strain Rate-Dependence of Yield Strength of Structural Steels

INFLUENCE OF STRAIN HARDENING ON BUCKLING/PLASTIC STRENGTH OF PLATES

Cyclic Loading Tests and Numerical Modeling of Concrete-Filled 700 MPa High-Strength Steel Tubes Incorporating Deep Plasticity

Effect of nonlinear strain paths on forming limits under isotropic and anisotropic hardening

Study on Tensile Ratio of High Strength Construction Steel

Constitutive model for cyclic behavior of mild steel under various strain amplitudes

A closed-form structural stress-strain relation and implications on plastic design limits in codes and standards

Effect of Strain Ratio on Cyclic Deformation Behaviour of 7050-T6 Aluminium Alloy

Strain Hardening under Large Deformation for AA5182

Research Progress on the Mechanical Property of High Strength Structural Steels