Effect of Pre-strain and Strain Rate on Deformation and Fracture Behavior of Automotive Grade Interstitial Free Steel Sheets

Anusha Mukhopadhyay,S. Das,G. Mukhopadhyay

DOI: https://doi.org/10.1007/s11665-024-10096-3

IF: 2.3

2024-09-25

Journal of Materials Engineering and Performance

Abstract:The influence of pre-strain and strain rate on the deformation behavior of two automotive grades of interstitial free (IF) steel sheets, known as EIF and HIF, with a thickness of 0.7 mm, was investigated. Tensile tests were conducted on as-received (0% pre-strain) and pre-strained (5, 10, and 15%) steels at five different strain rates ranging from 3.33 × 10 −5 to 1.66 × 10 −1 s −1 . The stress–strain data from these tests were analyzed to determine the strain-hardening exponent ( n ) and strain-hardening rate (d σ /d ε ), and to gain insights into the deformation behavior. The steels exhibited two distinct strain-hardening regimes, with a transition point at a true strain range of 0.035-0.05. Both n and d σ /d ε of the steels decreased with increasing pre-strain. While n and d σ /d ε decreased with increasing strain rate in the initial stage of deformation for as-received steel, these remained largely unaffected for the entire plastic deformation regime of pre-strained steels, which is a novel finding. Fractographic analysis revealed ductile fractures characterized by dimples. The size of these dimples decreased with increasing pre-strain but increased with increasing strain rate. TEM study of dislocation substructures and estimation of dislocation density were supplementary to this investigation.

materials science, multidisciplinary