The Effect of the Strain Rate on the Fretting Wear Properties of Thermally Compressed Inconel 625 Alloy

Zhi Jia,Yanjiang Wang,Jinjin Ji,Xuan Sun,Baolin Wei

DOI: https://doi.org/10.1002/adem.202000437

IF: 3.6

2020-09-09

Advanced Engineering Materials

Abstract:<p>The strain rate during the thermal deformation process has a decisive effect on the performance of the material. In this research, Inconel 625 alloy was subjected to thermal compression at different strain rates to obtain fretting wear samples with different microstructures. The effects of the recrystallized grain morphologies, textures, and microhardness values on the fretting wear resistance of thermally compressed Inconel 625 were studied. The results demonstrate that the thermally compressed Inconel 625 alloy underwent severe oxidation reactions during fretting wear, mainly Fe oxides. At an equal temperature, as the strain rate of thermal compression increased, the friction coefficient and wear volume were found to first decrease and then increase. When the strain rates during thermal compression were 0.1 and 1 s⁻¹, the workpiece was in a relatively fine recrystallized grain form without texture and with high hardness. At this time, the thermally compressed Inconel 625 had a low friction coefficient, a small volume of wear, and a large number of oxides on its surface. Therefore, the thermal deformation microstructure has a great influence on the wear resistance. This paper proposes to improve the fretting wear resistance of the workpiece by adjusting the strain rate during the thermal deformation process.</p><p>This article is protected by copyright. All rights reserved.</p>

materials science, multidisciplinary

What problem does this paper attempt to address?

The paper primarily explores how the microstructural changes of Inconel 625 alloy after hot compression treatment at different strain rates affect the material's friction and wear performance. Specifically, the research aims to reveal the relationship between strain rate and the material's anti-friction and wear performance, and to propose methods to improve the workpiece's anti-friction and wear performance by adjusting the strain rate during the hot deformation process.

The core contributions of the paper include the following points:

1. **Effect of Strain Rate**: The study found that at the same temperature, as the strain rate increases during the hot compression process, the material's friction coefficient and wear volume first decrease and then increase. When the strain rate is 0.1 and 1 s⁻¹, the workpiece exhibits a finer recrystallized grain structure, no significant texture, and higher hardness. At this time, the hot-compressed Inconel 625 alloy has a lower friction coefficient, smaller wear volume, and a large amount of oxides on the surface.

2. **Role of Microstructure**: The paper emphasizes the significant impact of hot deformation microstructure on the material's wear performance. By changing the strain rate, the grain size, texture, and hardness of the material can be controlled, thereby affecting the material's anti-friction and wear performance.

3. **Oxidative Wear Mechanism**: The study observed that the hot-compressed Inconel 625 alloy undergoes severe oxidation reactions during the friction and wear process, mainly generating iron oxides. As the strain rate increases, the amount of oxides generated in the wear area first increases and then decreases, with iron oxides being predominant. These oxide layers formed on the surface help to reduce the material's wear loss.

In summary, the paper aims to optimize the microstructure of Inconel 625 alloy by adjusting the strain rate during the hot deformation process, thereby improving its anti-friction and wear performance. This research is of great significance for components that need to operate in high-temperature environments in fields such as aerospace, chemical engineering, and nuclear energy, helping to enhance the safety and service life of these components.