Comparison in Deformation Behavior, Microstructure, and Failure Mechanism of Nickel Base Alloy 625 under Two Strain Rates

Meng Liu,Quanyi Wang,Yifan Cai,Dong Lu,Tianjian Wang,Yubing Pei,Hong Zhang,Yongjie Liu,Qingyuan Wang

DOI: https://doi.org/10.3390/ma14102652

IF: 3.4

2021-05-18

Materials

Abstract:Tensile deformation behavior and microstructure of nickel-base superalloy Inconel 625 are investigated under different strain rates of 5 × 10−4 s−1 and 5 × 10−5 s−1. According to the experimental results, yield strength and ultimate tensile strength of the alloy increase with the increase in strain rate in room temperature. Microstructure results indicate that the size of dimples is smaller in the tensile fracture surface at low strain rate than the high strain rate, and the number of dimples is also related to the strain rates and twins appear earlier in the specimens with higher strain rates. Apart from Hollomon and Ludwik functions, a new formula considering the variation trend of strength in different deformation stages is deduced and introduced, which fit closer to the tensile curves of the 625 alloy used in the present work at both strain rates. Furthermore, the Schmid factors of tensile samples under two strain rates are calculated and discussed. In the end, typical work hardening behavior resulting from the dislocations slip behavior under different strain rates is observed, and a shearing phenomenon of slip lines cross through the δ precipitates due to the movement of dislocations is also be note.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

The paper aims to study the tensile deformation behavior, microstructure, and failure mechanisms of the nickel-based superalloy Inconel 625 under different strain rates. Specifically, the research analyzes the hardening behavior of the material through micro-tensile tests conducted at two different strain rates (5×10^−4 s^−1 and 5×10^−5 s^−1) and fits the strain hardening index using different empirical equations. Additionally, the fracture surfaces were observed using an electron microscope to define slip characteristics and dislocation distribution, thereby further investigating the deformation behavior and failure mechanisms under different strain rates.

The study found that as the strain rate increased from 5×10^−4 s^−1 to 5×10^−5 s^−1, both the yield strength and tensile strength improved. The research also proposed a new "hybrid" equation to better describe the strength variation trends of the material at different deformation stages, with the fitting results being closer to the experimental data.