Abstract:This paper covers the development of tensile strain design models using a multidisciplinary approach, including fundamental fracture mechanics, small-scale material characterization tests, and large-scale tests of full-size pipes. The tensile strain design models are formulated in a four-level format. The Level 1 procedure provides estimated tensile strain capacity (TSC) in a tabular format for quick initial assessment. The initiation toughness alternatively termed apparent toughness is estimated from upper shelf Charpy impact energy. The Level 2 procedure contains a set of parametric equations based on an initiation-control limit state. The tensile strain capacity can be computed from these equations with the input of a pipe's dimensional and material property parameters. The apparent toughness is estimated from either upper shelf Charpy energy or upper shelf toughness of standard CTOD test specimens. The Level 3 procedure uses the same set of equations as in Level 2 and the toughness values are obtained from low-constraint tests. In the Level 3 procedure, two limit states based on either initiation control or ductile instability can be used. The Level 4 procedure allows the use of direct FEA calculation to develop crack driving force relations. The same limit states as those in Level 3 may be used. The Level 4 procedures should only be used by seasoned experts in special circumstances where lower level procedures are judged inappropriate.The tensile strain design models may be used for the following purposes:(1) The determination of tensile strain capacity for a given set of material properties and flaw size.(2) The determination of acceptable flaw sizes for a given set of material properties and target tensile strain capacity.(3) The selection of material properties to achieve a target strain capacity for a given flaw size.(4) The optimization of the tensile strain capacity by balancing the requirements of material parameters, such as weld strength (thus weld strength mismatch level) versus toughness.The application of the tensile strain design models is given in a companion paper.

A general model to predict torsion and curvature increments of tensile armors in unbonded flexible pipes

Analytical and Numerical Models to Predict the Behavior of Unbonded Flexible Risers under Torsion

Analytical and Numerical Modeling for Flexible Pipes

Alternative analytical and finite element models for unbonded flexible pipes under axisymmetric loads

Torsional Response Analysis of Flexible Pipe Based on Theory and Finite Element Method

Mechanical Modeling of Tube Bending Considering Elastoplastic Evolution of Tube Cross-Section

Failure Characteristic Analysis of Tensile Armour Layer of Unbonded Flexible Riser under Axial Compression

Prediction of nonlinear mechanical characteristics for metallic strip flexible pipe with bend stiffener constraints

A Theoretical Method To Estimate The Fatigue Life Of Tensile Armors Of Flexible Pipes

A Computationally Efficient Dynamical Model of Fluidic Soft Actuators and Its Experimental Verification

Mechanical analysis of finned special-shaped tubes in bending-torsional coupling deformation

New effective bending rigidity and structural instability analysis of noncircular cross-section elastic rod model

A Finite Element Model for Prediction of the Bending Stress of Umbilicals

Behavior of Unbonded Flexible Risers Subject to Axial Tension

Prediction of Flexural Deformation of A Corroded Rc Beam with A Polynomial Tension-Stiffening Model

Flexible Riser Tensile Armour Stress Assessment in the Bend Stiffener Region

Helical Wire Behavior of Unbonded Flexible Pipes under Bending

A Finite-Strain Micromechanical Model for the Hyperelasticity of Tendons and Ligaments with Crimped Fibers

A hyperelastic constitutive model for soft elastomers considering the entanglement-dependent finite extensibility

Tensile Strain Models for Strain-Based Design of Pipelines

MECHANICAL BEHAVIORS OF METALLIC STRIP FLEXIBLE PIPE UNDER AXISYMMETRIC LOADS