Abstract:Abstract To correctly model the structural behavior of a flexible pipe, the contribution of all the layers must be completely understood, among them the interlocked carcass. That carcass is a metallic layer designed to provide radial stiffness to a flexible pipe, mainly supporting pressure differentials and thus preventing failure modes such as collapse and crushing, but its behavior under other loads is worth of investigation. This paper contributes to understanding the carcass behavior under tension. Given its complex helical and interlocked geometry, modelling the carcass through the Finite Element Method is a challenging task, not only due to the large size of the models, but also due to the nonlinearities and convergence difficulties that arise from the self-contacts at the interlocking. For these reasons, most works developed over the past decades have adopted an equivalent layer approach, in which the carcass is replaced by an orthotropic cylindrical layer with equivalent mechanical properties. Although practical, this approach disregards the effects from the interlocking, such as stiffness variations and stress concentrations. Therefore, aiming a more realistic representation and a better understanding of the mechanical behavior of the interlocked carcass, this work presents four different carcass finite element models to analyze this layer under tension loads. The first one is a complete three-dimensional finite element model of an interlocked carcass discretized with second order isoparametric solid elements and surface-to-surface contact elements. The second model consists of a version of the first one with the addition of an inner polymeric sheath. As for the third and fourth models, it was adopted the simplifying ring hypothesis, that is, a carcass with 90 degree lay angle, thus allowing the axisymmetric modelling of the two previous configurations, representing a substantial computational gain by using two-dimensional meshes. The results of those models are then presented and compared, and the validity of the adopted simplifying hypothesis is verified.

Analytical and Numerical Modeling for Flexible Pipes

A Full Layered Numerical Model for Predicting Hysteretic Behavior of Unbonded Flexible Pipes Considering Initial Contact Pressure

An Analytical Model to Predict the Bending Behavior of Unbonded Flexible Pipes

Short-Term Mechanical Analysis of Polyethylene Pipe Reinforced by Winding Steel Wires Using Steel Wire Spiral Structural Finite Element Model

Bending Behavior Modeling of Unbonded Flexible Pipes Considering Tangential Compliance of Interlayer Contact Interfaces and Shear Deformations

Alternative analytical and finite element models for unbonded flexible pipes under axisymmetric loads

A Novel Helix Contact Model for Predicting Hysteretic Behavior of Unbonded Flexible Pipes

Influence of Structural Parameters of Unbonded Flexible Pipes on Bending Performance

Finite Element Analysis of a Flexible Pipe Interlocked Carcass Under Tension Loads

Analysis of the Mechanical Behaviors of Fiber Reinforced Unbonded Flexible Pipe Under Combined Load

The Tensile Armour Behaviour of Unbonded Flexible Pipes Close to End Fittings under Axial Tension

Cross-Sectional and Dynamic Analyses of Flexible Pipes

Tensile strength of the unbonded flexible pipes

Residual Stress Evaluation And Buckling Analysis Of Carcass Layers In Flexible Pipes Using 3d Finite Element Model

Slip and Stress of Tensile Armors in Unbonded Flexible Pipes Close to End Fitting Considering an Exponentially Decaying Curvature Distribution

Validity and Limitation of Analytical Models for the Bending Stress of a Helical Wire in Unbonded Flexible Pipes

Mechanical Characteristics of Fiber-Reinforced Flexible Pipe Subjected to Axial Tensile Load

Equivalent Moduli of Carcass Layer in Flexible Pipes

An analytical approach for assessing the collapse strength of an unbonded flexible pipe

Cross-Sectional Design and Case Study for Flexible Pipe

Finite Element Model and Bending for Marine Composite Flexible Pipes